Kenwood Chef XL Sense KQL6200Z Handleiding (215 Pagina's)

Handleiding

/ 215

Je bekijkt pagina 12 van 215

8

To assemble

The splashguard assembly consists of

2 pieces: the head shield

(8

and the

splashguard

(9

.

The splashguard cannot be fitted to the

bowl unless the shield is fitted.

1 Raise the mixer head until it locks.

2 Clip the head shield upwards onto the

underside of the mixer head



until fully

located.

3 Fit the bowl onto the base.

4 Lower the mixer head.

5 Rest the splashguard on the bowl rim

and then slide forward until fully located



.

• During mixing, ingredients can be added

directly to the bowl via the feed chute.

6 To remove the splashguard simply slide

it away from the mixer bowl.

7 To remove the head shield, raise the

mixer head until it locks. Remove the

tool if fitted, then pull the head shield

downwards from the underside of the

mixer head.

Note: Only fit or remove the splashguard

when the mixer head is in the locked

position.

We recommend that the head shield

is removed regularly from the mixer

head for cleaning.

K-beater & Whisk

The tools are set to the correct height for

the bowl supplied in the factory and should

not require adjustment.

However, if you wish to adjust the tool use

a suitable sized spanner:

TYPE KQC51 = 15mm

TYPE KQL61 = 19mm

Then follow the instructions below:

1 Unplug the appliance.

2 Raise the mixer head and insert the

whisk or beater.

3 Lower the mixer head. If the clearance

needs to be adjusted, raise the mixer

head and remove the tool. Ideally the

whisk and K-beater should be almost

touching the bottom of the bowl

(1

.

4 Using a suitable spanner loosen the nut

sufficiently to allow adjustment of the

shaft

(2

. To lower the tool closer to the

bottom of the bowl, turn the shaft anti-

clockwise. To raise the tool away from

the bottom of the bowl turn the shaft

clockwise.

5 Re-tighten the nut.

6 Fit the tool to the mixer and lower the

mixer head. (Check its position see

points above).

7 Repeat the above steps as necessary

until the tool is set correctly. Once this is

achieved tighten the nut securely.

• Note: Spanner

(2

shown is for

illustration purpose only.

Dough Hook

This tool is set at the factory and should

require no adjustment.

To fit and use your

Splashguard

(8

+

(9

Tool Adjustment

/ 215

Bekijk gratis de handleiding van Kenwood Chef XL Sense KQL6200Z, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.