Handleiding
Je bekijkt pagina 30 van 173
30
PROBLEM
POSSIBLE CAUSE
SOLUTION
Burner will not
ignite
There is no power to the
range.
Check that range is properly connected to
120V power supply.
Burner will not
operate
First time use. Air still in
the gas line.
Turn on any one of the surface burner
knobs to release air from the gas lines.
Control knob is not set
correctly.
Push in knob before turning to a setting.
The burner port is
clogged.
Clean burner port opening using a stiff,
nylon toothbrush or a straightened paper
clip.
Burner Flames
are uneven,
yellow and/or
noisy
Burner port(s) are clogged.
Clean burner port opening using a stiff,
nylon toothbrush or a straightened paper
clip.
Burner caps are not
positioned properly.
Place burner caps so that the alignment
pins are properly aligned with the slots.
Propane gas is being used.
The range should be converted to LP gas
by a qualified technician.
Burner flame is
too high or too
low
Cooktop gas supply is not
correct.
Ensure the range is set for the correct gas
type. It is factory set for natural gas. If
connecting to LP gas, the burners should
be converted to LP gas with the orifice kit
supplied and the pressure regulator
converted to the LP gas setting by a
qualified technician.
The gas pressure is not
correct.
Make sure the pressure regulator is
installed correctly and the gas line
pressure is correct. See Installation
Instructions.
Burner makes
popping noises
The burner is wet.
Allow the burner to dry before using.
The burner cap or gas
spreader is not positioned
correctly.
Place burner caps so that the alignment
pins are properly aligned with the slots.
Excessive heat
around cookware
on cooktop
The cookware is not the
proper size for the burner.
Use cookware with a bottom surface
approximately the same size as the
cooking area and burner. Cookware
should not extend more than 1" (2.5 cm)
outside the cooking area. Adjust the flame
so that it does not come up around the
cookware.
Cooking results
are not what
expected
Using incorrect Cookware.
See the “Cookware” section.
The control knob is not set
to the proper heat level.
See the “Controls” section.
OVEN PROBLEMS
PROBLEM
POSSIBLE CAUSE
SOLUTION
Bekijk gratis de handleiding van Kenmore 76833, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kenmore |
| Model | 76833 |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 19808 MB |
