Kathrein UFO 102 handleiding
Handleiding
Je bekijkt pagina 46 van 53
UFOpro User Guide
4
UFO 220/16 >Basic Setting
This page is where you can modify or set the frequency for the RF modulation. UFO 220/16 has 16
non-adjacent channels.
Click the Apply button on the right side to make the change take effect.
Name Range Name Range
Bandwidth 6M, 7M, 8M RF level 0~63 (dBμV)
60~123 (dBmV)
Symbol Rate (KBaud) 4400~6956 Frequency (KHz) 48000~858000
Constellation QAM16/32/64/128/256
UFO 220/16 >Output
QAM Output will be different from the Receiver and Encoder module. Since the QAM module is an
output module like IP output, all services configured in receiver, encoder and IP input will be seen
here.
TS setting: Please refer to IP output service configuration.
LCN setting: You need to add NIT streams of all frequencies in the base TS (frequency), which
is used for your STB to automatically search and identify all the TS (frequencies) LCN information.
Check or reset Original Network ID and TS ID of each TS (frequency).Each TS should have
different IDs.
Fill the Original Network ID and TS ID of each TS (frequency) in the field of the base TS
(frequency) and then click Add to create a NIT stream for this TS (frequency).
Click +Descriptor then LCN Descriptor to check all the programs which are contained in this
frequency. Then set programs LCN.
Bekijk gratis de handleiding van Kathrein UFO 102, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kathrein |
| Model | UFO 102 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9971 MB |