Kathrein UFO 102 handleiding
Handleiding
Je bekijkt pagina 23 van 53
UFOpro User Guide
2
Unicast output setting: You should fill the unicast receiving end’s IP addresses in the
Destination IP Address box.
Destination MAC: Normally you do not need to enable the Destination MAC switch. Only in
some specific case where the unicast stream cannot be received due to unknown reasons, you
can enable Destination MAC and fill in the correct receiver MAC in instead of using unicast IP
addresses.
Constant Rate of any output channel/TS/port ought to be set manually about 2 Mbps higher
than the Effective Bitrates in the corresponding output channel/TS/port, since the Effective
Bitrates might fluctuate a little bit. If you set the Constant Rate much higher that the Effective
Bitrates, there will be lots of null packets in the output transport stream.
If you want to configure a batch of channels, please click “Batch Setting”.
Batch Setting of IP output channels is also similar to that of setting IP input.
Bekijk gratis de handleiding van Kathrein UFO 102, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kathrein |
| Model | UFO 102 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9971 MB |