Karcher Sensor Bp handleiding
Handleiding
Je bekijkt pagina 11 van 44
11
Operation
Working with SENSOR Bp
SENSOR Bp is also equipped with many of the well
known features of Kärcher upright vacuums.
The On / Off-Switch (20) is located on the left hand side
of the power head and is designed to be operated by
foot. A slight push will be sufficient for starting the motor,
another push will stop it again.
Before bringing the vacuum in working position, please
hold the handle firmly. Otherwise the upper part may fall
backwards! Push down the foot pedal (23) first.
Afterwards, the upper part of the machine can be tilted
into a comfortable working position. For cleaning under
furniture or upholstery, the top part can be tilted far back
(up to 180°). Working space will only be limited by the
height of the power head.
In breaks or after finishing work, it is mandatory to push
the filter bag housing upwards until the foot pedal snaps
in tactilely and audibly.
Only then the device can be safely placed on a solid
surface.
After finishing your work, the Power Pack should be
removed from the machine and recharged in order to
keep your
SENSOR Bp always ready to use.
Height Adjustment of Brush
In order to get an optimal cleaning result, the brush of
your
SENSOR Bp can be height adjusted in four steps.
The large adjustment wheel (21) on the right hand side
of the power head is intended for this purpose. These
settings are possible:
1 Largest engagement in the carpet, also carpets
with low pile height.
2 High sweeping performance, but perhaps faster
wear of the brush roller. Also for carpets with middle
pile height.
3 Lower sweeping performance. Also for carpets
with more pile height.
4 Lowest engagement in the carpet, also for long
pile carpets.
The numbers listed above will also be shown on top of
the adjuster (21a) according to the setting of the height
adjustment.
With these setting options, the optimal balance between
material protection, required pushing force, brush roller
wear as well as battery running time can be achieved. If
the cleaning performance is not sufficient, even in
position 1, the brush roller is worn and needs to be
replaced.
Please refer to section “Maintenance and Care” for
details. It has been proven that it makes sense to start in
position 2“ and change to diverting settings depending
on personal feeling or conditions on site.
20
23
21a
21
8.645-246.0 Manual Sensor Bp 12 36V Lithium
Bekijk gratis de handleiding van Karcher Sensor Bp, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Karcher |
| Model | Sensor Bp |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 6397 MB |
