Jung TKASVAL114WW handleiding

Handleiding

123456789101112131415161718192021222324/ 24

Afdrukken

Je bekijkt pagina 13 van 24

13

Bell button programming

Basic principle

• All of the devices on the DCM BUS have a unique serial number.

• When a bell button is programmed, the serial number of an indoor station is assigned

and saved in the EEPROM of the outdoor station. 1 or 2 indoor stations (serial num-

bers) can be assigned and triggered with each bell button.

• If no serial number is assigned to a bell button (state at delivery / serial number de-

leted), the light can be switched on by pressing this button.

Programming a bell button

Make sure that the indoor stations are connected to the DCM BUS and the mains voltage

is switched on (the LED on the power supply and control unit is illuminated).

!

The button layout must be set before the bell buttons are programmed.

!

The programming must be deleted before a previously programmed bell button

can be reprogrammed.

1 Initiation

press briefly LED flashes

Outdoor station in programming mode: flashes, pro-

gramming mode of the system is

switched on

2a By means of communication button at the indoor station

Press communication button of the

indoor station briefly (communica-

tion is established with the outdoor

station)

Press button briefly ... positive acknowledge tones sounds

at the outdoor and indoor stations

1)

1) If instead a programming block tone is audible, the outdoor station has been given a programming block.

The programming block can only be cancelled using the commissioning software.

123456789101112131415161718192021222324/ 24

Bekijk gratis de handleiding van Jung TKASVAL114WW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Bewakingscamera