Juki MF-3580 handleiding
Handleiding
Je bekijkt pagina 75 van 440
− 3 −
2. Installing the belt cover
(only for the sewing machine provided with a clutch motor)
1
2
3
4
5
4
A
C
C
C
3 - 5mm
B
Equal clearance on
the left and right
When your machine uses a clutch motor, it is necessary to
fi rstly mount the belt cover supplied with the unit over the
motor to ensure safety. The supplied belt cover is intended
for separately-available JUKI's exclusive mount base.
If you use a different mount base, a belt cover specifi c to
that mount base should be attached. If your mount base
is not provided with its exclusive belt cover as an acces-
sory, please contact the distributor or the manufacturer of
your mount base to get a belt cover specifi c to your mount
base.
1) Attach spacer
1
with three setscrews
2
.
2) Place V-belt
4
in belt cover
3
.
3) Pass belt cover
3
through the sewing machine pul-
ley. Put V-belt
4
on the pulley. Refer to "
2
-
7. Install-
ing the handwheel" for further information on the
handwheel.
4) Put V-belt
4
onto pulley
5
of the clutch motor.
5) Adjust the lateral position of belt cover
3
using the
projecting amount, 3 to 5 mm, of spacer
1
as a
guide. Adjust the longitudinal position of the cover so
that the clearance provided between the rim of spacer
1
and belt cover
3
is uniform on the right and left
sides (
A
). Once the belt cover is correctly positioned,
fi x the belt cover on the table by tightening four
washers and four wood screws in the hole
C
in the
belt cover.
6) Fit plug in section
B
. This hole is used as the oil hole
for the connecting rod asm. (40068581).
Bekijk gratis de handleiding van Juki MF-3580, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Juki |
| Model | MF-3580 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 79694 MB |
