JET JWJ-8HH-BLK handleiding
Handleiding
Je bekijkt pagina 8 van 28
8
7.0 Setup and Assembly
Do not connect machine to
power source before or during setup and
assembly.
This machine has an industrial-
grade low-friction corrosion-resistant coating
on the infeed and outfeed tables and the fence.
While the coating is durable, it can be damaged
if metal or other hard and/or sharp objects
strike, gouge, or scratch the surface. Significant
damage to the coating may affect its
performance. Use care when unpacking and
locating the machine and during all setup and
assembly procedures.
Your new jointer is shipped in two cartons: the stand
carton and the jointer carton. Carefully unpack the
stand, jointer, and any loose items. Inspect for
damage. Any damage should be reported
immediately to your distributor and shipping agent.
Do not discard any shipping material until the jointer
is assembled and running properly. Before
proceeding further, read your manual thoroughly to
familiarize yourself with proper assembly,
maintenance and safety procedures.
Remove the protective coating from the cutterhead
and loose items packed with the machine. This
coating may be removed with a soft cloth moistened
with Kerosene. Do not use acetone, gasoline or
lacquer thinner for this purpose. Do not use solvents
on plastic parts.
Compare the contents of your cartons with the
following parts list to make sure all parts are
included. Missing parts, if any, should be reported to
your distributor.
7.1 Shipping Contents
The items below are shipped with the jointer.
Stand Contents (Figure 7-1):
• 1 – Stand with Motor – A
• 1 – Dust Port – B
• 4 – Dust Port Mounting Hardware – C
• 4 – Rubber Feet with M10 Hex Nuts – D
• 1 – Stand Door (not shown)
Jointer Contents (Figure 7-2):
• 1 – Bed Assembly – E
• 1 – Cutterhead Guard Assembly – F
• 1 – Belt Guard Assembly - G
• 1 – Fence Base Assembly – H
• 2 – Drive Belts - I
• 3 – Hex Cap Screws, M10 x 20 – J
• 3 – Lock Washer, 10mm – K
• 3 – Flat Washer, 10mm - L
• 1 – Lifting Bar Assembly – M
• 1 – Handwheel, Key, & Washer – N
• 1 – Fence Handle – P
• 1 – Fence – Q
• 2 – Push Blocks – R
• 6 – Hex Wrenches, 2.5, 3, 4, 5, 6, 8mm – S
• 1 – Locking Handle/Bolt – T
• 1 – Owner’s Manual (not shown)
• 1 – Warranty Card (not shown)
Tools Contents (Figure 7-3):
• 2 – Star-Point Screwdrivers
• 5 – Knife Inserts
• 5 – Knife Insert Screws, M5 x 12
Figure 7-1
Figure 7-2
Figure 7-3
Bekijk gratis de handleiding van JET JWJ-8HH-BLK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JET |
| Model | JWJ-8HH-BLK |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9382 MB |
