JET JJP-10BTOS handleiding
Handleiding
Je bekijkt pagina 22 van 40
22
16.0 Troubleshooting the JJP-10BTOS
16.1 Performance Troubleshooting – Jointer
Trouble
Probable Cause
Remedy
Finished stock is
concave on back
end.
Knife is higher than outfeed table.
Align cutterhead knives with outfeed
table. See sect. 12.1, Cutterhead
Knife Adjustment.
Finished stock is
concave on front end.
Outfeed table is higher than knife.
Align cutterhead knives with outfeed
table. See sect. 12.1, Cutterhead
Knife Adjustment.
Chip out.
Cutting against the grain.
Cut with the grain whenever possible.
Dull knives.
Sharpen or replace knives.
Feeding workpiece too fast.
Use slower rate of feed.
Cutting too deeply.
Make shallower cuts.
Knots, imperfections in wood.
Inspect wood closely for
imperfections; use different stock if
necessary.
Fuzzy grain.
Wood has high moisture content.
Allow wood to dry or use different
stock.
Dull knives.
Sharpen or replace knives/inserts.
Cutterhead slows
while operating.
Feeding workpiece too quickly, or
applying too much pressure to
workpiece.
Feed more slowly, or apply less
pressure to workpiece.
“Chatter” marks on
workpiece.
Knives incorrectly set.
Set knives properly as described in
sect. 12.1, Cutterhead Knife
Adjustment . Check that knife slots
are clean and free of dust or debris.
Feeding workpiece too fast.
Feed workpiece slowly and
consistently.
Cutting too deeply.
Make shallower cuts.
Uneven knife marks
on workpiece.
Knives are nicked, or out of
alignment.
Align knives per sect. 12.1,
Cutterhead Knife Adjustment.
Replace nicked knives.
Bekijk gratis de handleiding van JET JJP-10BTOS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JET |
| Model | JJP-10BTOS |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10551 MB |
