Jenn-Air JDPSS244PM handleiding
Handleiding
Je bekijkt pagina 7 van 80
7
NOTE: To exit “Kosher Consumer Friendly Mode” at any time, press the “Cancel” button or you can wait 75 hours.
Kosher Consumer Friendly Mode: When turned on, will disable all of the buttons on the dishwasher except for the cancel key, and
disable the light inside the tub (if equipped) for a time period of 75 hours. If this mode is turned on during a cycle, then the status lights
at the end of cycle will not turn off when the door is opened and then re-closed. To exit this mode, press the “Cancel” button, or wait
75 hours.
NOTE: The Auto Door Open feature name differs by model. It can also be referenced as Auto Open Dry, Door Open Dry, Natural Dry or
Air Dry.
ERROR CODES
ERROR CODES/BLINKING LIGHTS
Issue
Code Shown
(7 Seg
Display)
(if present)
Code Shown on
Front Panel LED*
(# blinks, Pause,
# blinks)
What will
happen?
What to do?
Dishwasher
fails to operate
ll valve
correctly
F1E1
1 Pause 1 Pause -
pause, repeat
Drain sequence
will begin,
machine
operation will be
prevented
Turn off water to unit (if possible).Turn off power to
unit. If the water cannot be turned off, DO NOT turn off
power and keep door closed. Press Cancel key one
time to silence alarm tone. Call service.
Motor
controller
failure
F1E2
1 Pause 2 Pause,
repeat
Cycle ends Call service
No water
present at
dishwasher
H2O
8 Pause 1 Pause -
pause, repeat
Cycle is paused
Ensure ll hose is connected to product. Ensure water
supply is turned ON. Press Start to resume cycle. If
alarm still present, call service.
Wash motor
failure
F7E1/F7E2
7 Pause 1 Pause,
repeat/7 Pause 2
Pause, repeat
Cycle ends Call service
Dishwasher
overlls
F8E4
8 Pause 4 Pause -
pause, repeat
Drain sequence
will begin,
machine
operation will be
prevented
For Professional Installers
Turn off water to unit (if possible). Turn off power to
unit. If the water cannot be turned off, DO NOT turn off
power and keep door closed. Press Cancel key one
time to silence alarm tone. Call service.
For Self Installers
■ Press CANCEL button twice or cycle power. This may
clear the issue.
■ Check to see if the wire connector is connected to
the oat switch on the drip tray. See step 45. If the
wire is off, reconnect and then hit the cancel button
twice.
■ Check to see if there is any water in the drip tray.
If water is in the drip tray, remove the water and
reinstall the drip tray. Make sure to connect the wiring
to the oat. Step 45. Check to see where water may
have leaked into the drip tray. (Check the water inlet
ttings in steps 15 and 16 to see if they are leaking)
■ If water was in the tray and no leaks were found, run
the product on the shortest installation cycle while
checking for leaks. The access panel should be off to
observe any leaks.
■ If problem still exists, call for service.
Fill valve stuck
on
F8E5
8 Pause 5 Pause -
pause, repeat
Drain sequence
will begin,
machine
operation will be
prevented
Turn off water to unit (if possible).Turn off power to
unit. If the water cannot be turned off, DO NOT turn off
power and keep door closed. Press Cancel key one
time to silence alarm tone. Call service.
Dishwasher will
not drain
F9E1
9 Pause 1 Pause -
pause, repeat
Cycle ends
If drain hose is connected to a garbage disposal,
conrm that drain hose is not clogged and disposal
plug has been knocked out. If unit still will not drain, call
service.
Water
present under
dishwasher
FAE5
10 Pause 5 Pause -
pause, repeat
Cycle ends Call service.
User interface
service
communication
fault
F6E1
6 Pause 1 Pause -
pause, repeat
Product will not
able to start or
resume cycles
Call service.
Bekijk gratis de handleiding van Jenn-Air JDPSS244PM, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jenn-Air |
| Model | JDPSS244PM |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 15337 MB |
