Janome Travel Mate TM50 handleiding
Handleiding
Je bekijkt pagina 53 van 58
51
Warning Sign Cause Try this
1. The start/stop button is pressed with the foot control
connected.
2. The foot control is out of order.
(The foot control sign keeps blinking.)
Disconnect the foot control.
Contact the service center
or the store from whom the
machine was purchased.
The machine is started the with the presser foot raised. Lower the presser foot and
start the machine again.
The bobbin winder spindle is shifted to the right. Shift the bobbin winder
spindle to the left for
stitching.
The machine will stop if the buttonhole is sewn without
lowering the buttonhole lever.
Lower the buttonhole lever
and start the machine
again.
The machine is started after halting due to overload.
Wait for at least 15 seconds
to restart.
Turn the power switch OFF.
Remove tangled threads
around take-up lever, hook
race.
(E1-E7) The machine does not work properly due to a problem in
the control circuit.
Contact the service center
or the store from whom the
machine was purchased.
It is not abnormal that a faint humming sound comes out from inside the machine.
LCD display may get warm when the machine has been used for hours.
Audible Signal The Buzzer sounds when:
pip Normal operation.
pip-pip-pip Invalid operation or malfunction.
peep E1-E7 error occurred.
pip pi-pi-pi-peep Buttonhole is completed.
Problems and Warning Signals
If a buzzer sounds and the LCD display shows a warning sign, follow the guidance below.
Bekijk gratis de handleiding van Janome Travel Mate TM50, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Travel Mate TM50 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 6811 MB |
