Janome MyLock 454D handleiding
Handleiding
Je bekijkt pagina 12 van 48
10
Adjusting the Stitch Length
To adjust the stitch length, turn the stitch length dial.
The larger the number, the longer the stitch length.
The smaller the number, the shorter the stitch length.
(1) Stitch length dial
(2) Setting mark
The standard stitch length setting for serging stitch is “3”
(approximately 3 mm).
The dial clicks when you turn the dial to 3.
The stitch length can be adjusted while sewing.
(3)
(4)
NOTE:
The stitch length can be adjusted from 1 mm to
4 mm. Position “R” is for rolled hemming and narrow
hemming (approximately 1.5 mm).
Adjusting the Differential Feed Ratio
Adjust the differential feed ratio when sewing fabrics that
tend to stretch or pucker.
The differential feed ratio can be altered by turning the
differential feed dial.
The number on the dial indicates the ratio between the
main and the sub feed motion.
(1) Differential feed dial
(2) Setting mark
• Set the dial at 1.0 for regular sewing. The differential
dial clicks when you turn the dial at 1.0.
• Set the dial at a lower number when sewing lightweight
fabrics that tend to pucker.
• Set the dial at a higher number when sewing stretch
fabrics such as knits.
(Refer to page 24)
(3) Stretched
(4) Gathered
(1)
(2)
(1)
(2)
NOTE:
When you sew at a short stitch length, try following
two methods together for better results:
• Tighten the needle thread tension.
• Tighten the looper thread tension and/or move the
lower knife to the right.
(1)
(2)
(1)
(2)
Bekijk gratis de handleiding van Janome MyLock 454D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | MyLock 454D |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 6651 MB |
