Janome Memory Craft 100E handleiding
Handleiding
Je bekijkt pagina 45 van 112
43
Example:
In-The-Hoop Designs <Rattles>#5+#6
Creating the handle with monograms
1.
Select #6 in the editing mode. Edit monograms as
you like (refer to page 59)
2.
Change the sewing order so that pattern 6 be sewn
at the end (refer to page 64).
(4)
(5)
4. 5.
6.
7.
8.
1. 2.
3.
3.
Attach a stabilizer on the wrong side of the fabric 3
and set the fabric in embroidery hoop (refer to pages
26-27). Attach the embroidery hoop on the
carriage (refer to page 28).
Embroider monograms and patterns. Apply glue on
the inside edge of the embroidery hoop as shown.
(1) Fabric 3 (right side)
(2) Stabilizer
(3) Glue
8.
Stitch the opening by hand to close it.
Attach the stuffed doll and the rattle together to hide
the seam.
(2)
(2)
(1)
(3)
NOTE:
Apply a thin layer of glue to baste the fabric in place
where it will not overlap with the stitches. If glue
gets on the needle or bobbin holder, it can cause
poor quality of sewing, damage or malfunction of the
machine.
4.
Place fabric 4 with the right side down on the fabric 3.
Embroider the rest of the design. After sewing is
nished, remove the fabrics from the embroidery
hoop.
(4) Fabric 4 (wrong side)
5.
Remove stabilizer from fabric 3 if necessary.
(2) Stabilizer
6.
Cut the fabrics along the cut-off line (outmost seams)
with scissors.
(5) Cut-off line
7.
As in steps
9.
to
11.
of “Creating the doll”, make a slit
along the curve, turn it over through the opening, and
stuff it with cotton.
Bekijk gratis de handleiding van Janome Memory Craft 100E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Memory Craft 100E |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 24843 MB |
