Janome Memory Craft 1000 handleiding
Handleiding
Je bekijkt pagina 32 van 212
30
1. 2.
Winding the bobbin
Bobbin winding when the extra spool pin is
attached
If you want to wind the bobbin with the extra spool
pin while sewing, draw the thread around the bobbin
winding tension disk as shown.
(1) Bobbin winding tension disk
(3)
(6)
(5)
(4)
3. 4.
(8)
(7)
(1)
(2)
5.
6.
7.
NOTE:
Set the speed control slider at the fastest position (refer
to page 15).
1.
Pull the thread from the spool.
Hold the thread with both hands and pass the thread
into the bobbin winding tension disk.
Draw the thread to the left and forward around the
thread guide.
Firmly pull the thread to the right while holding it with
both hands.
(1) Bobbin winding tension disk
(2) Disk
2.
Put the bobbin on the bobbin winder spindle.
Be sure that the bobbin snaps into the place.
(3) Bobbin
(4) Slit
(5) Bobbin winder spindle
(6) Spring (Projection)
3.
Pass the thread to the bobbin.
Hold the thread with both hands and wind it around
the bobbin clockwise several times.
4.
Insert the thread into one of the slits of the ange
plate and pull the thread to cut.
(7) Flange plate
(8) Slit
5.
Push the bobbin to the right. The visual touch screen
will show the bobbin winding sign.
6.
Start the machine.
Stop the machine when the bobbin is fully wound and
stops spinning.
Return the bobbin winder spindle to its original
position.
NOTE:
Do not move the bobbin winder spindle while the
machine is running.
7.
Remove the bobbin. Cut the thread with one of the
slits of the ange plate.
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
Bekijk gratis de handleiding van Janome Memory Craft 1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Memory Craft 1000 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 41253 MB |
