Janome Horizon Memory Craft 7700QCP Handleiding (96 Pagina's)

Handleiding

51

Square (Sensor) buttonholes

Machine settings

Pattern: 23 (Buttonhole)

Thread tension: AUTO

Presser foot: Automatic buttonhole foot R

Foot pressure: 7

Sensor buttonhole

Patterns number 23 and 25 to 33 are sensor buttonholes.

The size of a buttonhole is automatically set by placing a

button in the rear of automatic buttonhole foot R.

The button holder of the foot takes a button size of 1 cm

(3/8 ”) to 2.5 cm (1”) in diameter.

When selecting the sensor buttonholes, the LCD screen

advise you to lower the buttonhole lever.

NOTES:

It is sometimes necessary to change buttonhole size to

match certain heavy or specific fabrics and threads.

Make a test buttonhole on an extra piece of the fabric to

check your settings.

The preset width of the buttonhole is suited for ordinary

buttons.

Apply an interfacing to stretch or fine fabrics.

Sewing

z Press the needle up/down position button to raise the

needle. Attach the automatic buttonhole foot R

snapping the pin into the groove of the foot holder.

You may lift the presser foot lifter to the extra lifted

position when placing the automatic buttonhole foot

under the foot holder.

1 Groove

2 Pin

x Pull the button holder to the back, and place the

button in it. Push it together tightly on the button.

3 Button holder

NOTE:

If the button is extremely thick, make a test buttonhole

on an extra piece of the fabric.

If it is difficult to fit the button through the test buttonhole,

you can lengthen the buttonhole by pulling the button

holder back a little. The length of the buttonhole will be

increased.

2

1

z

3

x

Bekijk gratis de handleiding van Janome Horizon Memory Craft 7700QCP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.