Janome Horizon Memory Craft 7700QCP Handleiding (96 Pagina's)

Handleiding

11

Changing the Presser Foot

WARNING:

Turn the power switch off before changing the presser

foot.

Removing the presser foot

Raise the needle to its highest position and raise the

presser foot lifter.

Press the red button on the back of the foot holder.

The presser foot will drop off.

1 Red button

2 Presser foot

NOTE:

If the dual feed device interferes when pressing the red

button, shift the dual feed device away.

3 Dual feed device

Attaching the presser foot

Place the presser foot so that the pin on the foot lies just

under the groove of the foot holder.

Lower the presser bar to lock the foot in place.

Each foot is marked with an identification letter.

4 Groove

5 Presser foot

6 Identification letter

Removing and Attaching the Foot Holder

WARNING:

Turn the power switch off before removing or attaching

the foot holder.

Remove the needle for easy operation.

Removing the foot holder

Raise the presser foot and loosen the thumbscrew.

Remove the foot holder.

1 Thumbscrew

2 Foot holder

Attaching the foot holder

Attach the foot holder to the presser bar from the rear.

Tighten the thumbscrew securely with the screwdriver.

3 Presser bar

Attach the needle after installation of the foot holder.

NOTE:

Lower the presser foot when loosening and tightening

the thumbscrew if it is hard to access.

1

2

3

4

5

6

1

2

3

Bekijk gratis de handleiding van Janome Horizon Memory Craft 7700QCP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.