Janome Horizon 7700 handleiding
Handleiding
Je bekijkt pagina 43 van 96
41
Overcasting Stitches
Overcasting with zigzag stitch
Machine settings
Pattern: 9 or 10 (Utility)
Thread tension: AUTO
Presser foot: Overcasting foot C
Foot pressure: 7
Place the fabric edge next to the guide of the foot and
then sew.
1 Edge of fabric
2 Guide
CAUTION:
When you use the overcasting foot C, you must set the
zigzag width at 4.5 or wider to prevent the needle from
hitting the wires on the foot.
Multiple zigzag stitch (Tricot stitch)
Machine settings
Pattern: 11 (Utility)
Thread tension: AUTO
Presser foot: Zigzag foot A
Foot pressure: 7
This stitch is used to finish a raw edge of synthetics and
other stretch fabrics that tend to pucker.
Sew along the fabric edge leaving an adequate seam
allowance.
After sewing, trim the seam allowance close to the
stitches.
Overcasting stitch
Machine settings
Pattern: 12 (Utility)
Thread tension: AUTO
Presser foot: Overcasting foot C
Foot pressure: 7
This stitch can be used to simultaneously seam and
overcast edges of fabrics.
Use this stitch when you do not need to open seams flat.
Place the fabric edge next to the guide of the foot and
then sew.
1 Edge of fabrics
2 Guide
NOTE:
The stitch width cannot be changed to less than 4.5.
2
1
2
1
Bekijk gratis de handleiding van Janome Horizon 7700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Horizon 7700 |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 11361 MB |
