Janome DC4030PR handleiding
Handleiding
Je bekijkt pagina 15 van 44
13
w
e
Threading the Machine
• Threading the machine
q Up/down needle position button
w Spool
* Raise the thread take-up lever to its highest position.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off as shown.
z Draw the end of the thread around the upper thread
guide.
x While holding the thread near the spool w, draw the
end of the thread down around the check spring holder.
c Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
v Pass the thread through the lower thread guide. Slide
the thread behind the needle bar thread guide on the
left. Thread the needle from front to back, or use a
needle threader.
zx
cv
q
zx
cv
w
zc
x
v
q
r
w
t
NOTE:
The needle threader can be used with a #11 to #16
needle or a blue tipped needle. Thread size 50 to 90
should also work well.
Needle Threader
q Knob
w Hook
e Guide (a)
r Guide (b)
t Holder plate
z Lower the presser foot. Raise the needle to its highest
position. Pull down the needle threader knob q as far
as it will go. The hook comes out through the needle
eye from behind.
x Draw the thread from guide (a) e to guide (b) r and
under the hook w. Draw the thread up along the right
side of the guide (b) r and slip the thread in between
the guide (b) and the holder plate t.
c Raise the knob in the direction of the arrow on the
illustration, drawing the thread loop through the
needle.
v Pull the thread through the needle eye.
CAUTION:
Turn off the power switch when using the needle
threader.
Bekijk gratis de handleiding van Janome DC4030PR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | DC4030PR |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 4782 MB |
