Jackson DynaStar handleiding
Handleiding
Je bekijkt pagina 29 van 86
07610-004-66-53-F
22
TROUBLESHOOTING
PROGRAMMING
PROGRAMMING
To access programming, the machine should be on and not in cycle.
Programming buttons (up-arrow, down-arrow, and select) are hidden
on display and are shown below as red outlines.
Factory Setup (Model Selection)
1. Press and hold I and III buttons until “Program” starts ashing (2–3 seconds).
2. Press select button.
3. Use up-arrow or down-arrow button to change program number to correct
number in table, based on model.
4. Press select button.
5. “Program” will ash.
6. Press delime button to exit.
PROGRAM
PROGRAM
SEE TABLE
READY
CYCLE 1
150
F
A guide to locating hidden
buttons is located behind
front panel. Lay guide over
display and press where
indicated. There's also a
printable guide at the end
of this manual.
Pgrm # Model
2 DynaStar
3 DynaStar VER
4 DynaStar NB
Bekijk gratis de handleiding van Jackson DynaStar, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DynaStar |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 12043 MB |
