Jackson DishStar HT handleiding
Handleiding
Je bekijkt pagina 16 van 78
07610-004-37-13-S
9
3. The amount of detergent might need adjustment depending on water quality and
type of detergent. The amount of rinse-aid might need adjustment depending
on water hardness and results. Refer to HT Setpoints section for instructions on
adjusting amount of chemicals being dispensed.
LT/LT-H
4. Hold each prime switch (Detergent, Rinse-aid, and Sanitizer) until the respective
chemical can be seen entering the wash tank.
5. Detergent is dispensed as required during the wash cycle by the timer. The
amount of detergent might need to be increased or decreased depending upon
water quality and type of detergent.
6. Rinse-aid is dispensed as required into the nal rinse. The amount of rinse-aid
might need to be adjusted depending upon water hardness and results.
7. Sanitizer is dispensed proportionally into the nal rinse water line. The amount
of sanitizer might need to be adjusted depending on concentration.
8. See Programming Chemical Feeder Pumps (LT/LT-H) section to adjust chemical
amounts using the universal timer.
INSTRUCTIONS
INSTALLATION
PRIMING CHEMICAL
FEEDER PUMPS
PROGRAMMING
CHEMICAL FEEDER
PUMPS (LT/LT-H)
To access programming mode, machine must be ON and between cycles.
The PROGRAM (PGM) light will be ashing.
1. Locate universal timer. On the timer, locate programming board and
programming buttons.
8 7 6 5 4 3 2 1
ON
C
H
E
C
K
F
U
S
E
Universal timer is
located on control panel.
Use Parts section of this
manual for reference.
LT/LT-H DIP-switch Settings
(0 = On, X = Off)
←
ON
X X X X
0 0 0 0
8 7 6 5 4 3 2 1
Bekijk gratis de handleiding van Jackson DishStar HT, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DishStar HT |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 11176 MB |
