Jackson DishStar HT-E handleiding
Handleiding
Je bekijkt pagina 23 van 54
07610-004-43-79-D
16
DELIMING
OPERATION
In order to maintain the machine at its optimum performance level, lime and corro-
sion deposits must be removed. The frequency for deliming will be based on water
conditions. A deliming solution is available from your chemical supplier. Read and
follow all instructions on the label.
To delime the dishmachine:
1. Remove the rinse arms and place in sink with deliming solution (leave for the
amount of time recommended by the chemical supplier).
2. Replace the rinse arms.
3. Follow the Filling the Wash Tub section of this manual.
4. Open the door and add the amount of deliming solution recommended by the
chemical supplier.
5. Close the door and press the "Delime" button on the display. The status will
display "DELIME."
6. Press the "Start" button.
7. The machine will delime, drain, and rell.
8. Wait ve minutes, then inspect the machine. If the machine is not delimed,
run again.
9. When clean, press the "Delime" button. The status will display "READY."
10. Run the machine through two regular cycles to remove residual deliming
solution.
11. The machine is now ready for normal operation.
DELIMING
If this machine is equipped
with an HTS-11 scale
prevention and corrosion
control device and lime is
becoming a frequent
problem, the cartridge
needs to be replaced.
To order a replacement
cartridge, see the
Plumbing Options page.
155
F
DELIME
ON
Bekijk gratis de handleiding van Jackson DishStar HT-E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DishStar HT-E |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 8316 MB |
