Jackson DishStar ADA-SEER handleiding
Handleiding
Je bekijkt pagina 16 van 60
9
07610-004-99-71-B
INSTRUCTIONS
INSTALLATION
Chemical feeder pumps need priming when the machine is rst installed or if the
chemical lines have been removed and air was allowed to enter.
CAUTION! Water must be in the sump and wash tank before dispensing chemicals.
1. Verify the proper chemical tube stiener inlet is in the proper container.
2. To prime detergent pump, press and hold prime switch toward "Detergent" until
display shows timer. Priming cycle defaults to 70 seconds. Observe wash tank
during priming cycle. If too much detergent, press prime button to stop priming
cycle. If not enough, run priming cycle again.
3. To prime rinse-aid pump, press and hold prime switch toward "Rinse Aid" until
display shows timer. Priming cycle defaults to 180 seconds.
4. The amount of detergent might need adjustment depending on water quality and
type of detergent. The amount of rinse-aid might need adjustment depending on
water hardness and results. Refer to next section for instructions on adjusting
amount of chemicals being dispensed.
PRIMING CHEMICAL
FEEDER PUMPS
WARNING! Some of the
chemicals used in
dishwashing may cause
chemical burns if they
come in contact with skin.
Wear protective gear when
handling these chemicals.
If any skin comes in
contact with these
chemicals, immediately
follow the instructions
provided with the
chemicals for treatment.
!
WARNING
!
CAUTION
70
180
Bekijk gratis de handleiding van Jackson DishStar ADA-SEER, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | DishStar ADA-SEER |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 7542 MB |
