Jackson Delta 1200 handleiding
Handleiding
Je bekijkt pagina 21 van 55
SECTION 5: SERVICE PROCEDURES
REPLACING THE CHEMICAL FEEDER PUMP MOTOR
17
Jackson glasswasher machines come equipped with chemical
feeder pumps to ensure proper ware washing results.
Occasionally, the motors operating these pumps may need
replacing to maintain optimum performance.
Jackson offers all of the repair parts necessary for performing
this task.
The instructions provided here are for maintenance personnel
only. Unauthorized persons should not attempt any of the
steps contained in these instructions.
CAUTION: many of the instructions and steps within this doc-
ument require the use of tools. Only authorized personnel
should ever perform any maintenance procedure on the dish-
machine!
PREPARATION
1. Power must be secured to the unit at the service breaker.
Tag or lock-out the service breaker to prevent accidental or
unauthorized energizing of the machine.
2. Ensure that incoming water to the machine is secured either
by use of a shut-off valve or disconnecting the incoming water
line.
3. The unit must be drained completely with the drain stopper
removed.
T
OOLS REQUIRED
The following tools will be needed to perform this maintenance
evolution:
• Phillipshead Screwdriver
• Needle-nose Pliers
• Wire Cutters
• Wire Strippers
• Crimping Tool
TIME REQUIRED
It is estimated that it will take (1) person thirty minutes per
motor to perform this task, not including all of the items indi-
cated in the section entitled “PREPARATION.”
IMPORTANT NOTES
1. Read these instructions thoroughly before attempting this
maintenance task. Become familiar with the parts and what
actions need to be taken. This will save time in the long run!
2. These instructions show steps on only (1) of the three
motors. However, the steps are the same for each one.
STEPS
1. Remove the front door.
2. Remove the electrical box cover with the phillipshead screw-
driver.
3. The cover must be laid down close to the control box
because of the attached wires. Be careful not to yank out or
damage any of the wires as you move the cover.
4. Determine which motor you wish to replace, or which one
you wish to start with. Trace the wires leading from the motor
to its corresponding prime switch. Trace the other wire from
the motor to determine where it is connected.
5. With the needle-nose pliers, remove the motor wire from the
prime switch, being careful not to damage the prime switch in
the process. (If the prime switch is damaged, it will need to be
replaced. Refer to the parts section of the technical manual for
part numbers.)
Removing the screws for the electrical box cover.
Removing the electrical box cover.
Delta 115/Delta 1200 Technical Manual 07610-003-62-15-M
Issued: 10-27-08 Revised: 11-19-2015
Bekijk gratis de handleiding van Jackson Delta 1200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | Delta 1200 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 11193 MB |
