Jackson Conserver XL-HH handleiding
Handleiding
Je bekijkt pagina 16 van 64
07610-003-92-84-P
10
Electrical and grounding connections must comply with the applicable portions of the
National Electrical Code ANSI/NFPA 70 (latest edition) and/or other electrical codes.
Disconnect electrical power supplies and place a tag at the disconnect switch to
indicate that you are working on the circuit.
Refer to the data plate for machine operating requirements, machine voltage, total
amperage load, and serial number.
The main power terminal blocks (for the dishmachine and for the rinse booster
heater, if applicable) are located at the top of the machine. You will have to remove
the top cover to access these connections. Route incoming power lines within
conduit that will connect via ttings to the pre-punched holes in the back of the
Control Box. Install power and ground wires to lugs as indicated by the appropriate
decals in the control box. Use copper conductors only. Use of an anti-oxidation agent
is permissible on the power connections. Tighten all connections.
Verify the incoming voltage matches the voltage indicated on the decal next to the
incoming power pre-punched hole.
It is recommended that “DE-OX” or similar anti-oxidation agent be used on
all power connections.
The dishmachine should be located with an adequate exhaust hood or ventilation
system with provisions for venting. This is essential to permit efcient removal of
the condensation exhaust. Ensure that the exhaust system complies with applicable
codes and standards.
Any damage that is caused by steam and/or moisture due to improper ventilation
is NOT covered under the warranty.
Dishmachine ventilation requirements:
200 CFM
The exhaust system must be sized to handle this volume for the dishmachine to
operate properly.
The thermostats on this dishmachine have been set at the factory. They should only
be adjusted by an authorized service agent.
ELECTRICAL POWER
CONNECTIONS
Disconnect electrical
power at the breaker or
disconnect switch and
tag-out in accordance with
procedures and codes.
VENTILATION
NOTICE
i
INSTRUCTIONS
INSTALLATION
THERMOSTATS
NOTICE
Bekijk gratis de handleiding van Jackson Conserver XL-HH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Jackson |
| Model | Conserver XL-HH |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 9956 MB |
