IOGEAR GWLRSSKIT4KRX handleiding
Handleiding
Je bekijkt pagina 10 van 24
HDMIHDMI
Transmitter
HDMI
USB
Transmitter
HDMI
USB
Transmitter
Receiver
B
A, B or C
A
C
10
Switch Mode Display (N to 1, up to 10 transmitters to 1 receiver):
Adding Extra Transmitters in Switch Mode
1. Position the toggle switch to Switch Mode (SW) on both the Receiver and the
Transmitter.
2. Select the channel by pressing the ID button to the channel you want to use
making sure that both the transmitter and receiver channels match.
3. Connect 12V/1A power adapter to both the transmitter and the receiver and
wait till both the power LED and Link LED are solid.
4. Plug the HDMI cable from the receiver HDMI Out port to the transmitter HDMI
IN port (please refer to the below diagram).
5. The STA LED on the receiver will start to ash and turn solid, the STA LED
on the transmitter will then start to ash and turn solid, the paring is now
completed.
6. The transmitter Wi-Fi LED will then start to ash indicating the transmitter is
now transmitting contents. Please note that this step is necessary for every
additional transmitter added to the receiver.
7. After pairing, connect your HDMI wired display (using an HDMI cable) to the
Transmitter HDMI Out port (optional), and connect your source device to
HDMI In port on the Transmitter.
8. Make sure the receiver and the transmitter are on the same channel ID.
9. For adding additional transmitter, repeat step 3-8.
*Note: Every transmitter in the same location should be set to a dierent
channel ID.
Bekijk gratis de handleiding van IOGEAR GWLRSSKIT4KRX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IOGEAR |
| Model | GWLRSSKIT4KRX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1339 MB |
