Inventum VWM8030W handleiding
Handleiding
Je bekijkt pagina 46 van 108
46 • English
SELECTING ADDITIONAL FUNCTIONS
An additional function can be added to the main washing program before pressing the Start button.
Select a program and then press the function button to add one or more desired additional function(s).
Defautlt temperature
andprogram
Default spinning
rate in rpm
Delay Night
wash
Soil
level
Pre-
wash
Extra
rinse
Speed
wash
Steam
clean
Cotton 1400 � � � � � � �
Synthetic 1200 � � � � � �
Mix 1000 � � � � � � �
Bed linen 1000 � � � � � � �
Allergy 1000 � � � � � � �
20°C 1000 � � � � �
Fast 15 min. 800 � � � �
Sterile 70°C 1000 � � � �
Wool 600 � � � �
ECO 40-60 1400 �
Rinse & spin 1000 � � �
Spin & drain 1000 � �
Drum clean 400 � �
i
• For the maximum spinning rate, program time, and other details of the ECO 40-60 program, and other
details of theECO 40-60 program, please refer to the content on the Product Fiche.
• The table shows which cycle offers which options for adjustment.
• Adding an additional function will prolong the program time.
• Keep pressing the function button to make the desired selection of additional functions.
Manual interruption
To stop and cancel a washing program, press the START PAUSE button and hold it for 3 seconds. Select
the program SPIN & DRAIN and press the START PAUSE button. The appliance will run the program and at
the end of the program, theappliance pumps the water out of the drum. When the water is pumped out,
thedoor will be unlocked.
PAUSE button
The washing program can always be stopped by pressing the START PAUSE button. The washing program is
temporarily paused when the time remaining until program completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain
period of time, and it can be opened. To resume the washing program, first close the door and then press the
START PAUSE button.
ERRORS
In case of an error or fault, the program will be interrupted. An acoustic signal will warn about such
occurrence and the error will be flashing on the display [ E:XX ]. See the TROUBLESHOOTING TABLE for
more information.
Power supply failure
The washing program can always be stopped by pressing the START PAUSE button. The washing program is
temporarily paused when the time remaining until program completion is flashing on the display unit.
If there is no water in the drum and water temperature is not too high, then the door will unlock after a certain
period of time, and they can be opened. To resume the washing program, first close the door and then press
the START PAUSE button.
Bekijk gratis de handleiding van Inventum VWM8030W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Inventum |
| Model | VWM8030W |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 11546 MB |
