Handleiding
Je bekijkt pagina 23 van 48
English • 23
Do not use hard brushes, steel wool, abrasives (such as toothpaste), organic solvents (such as alcohol, acetone, oil, etc.),
boiling water, acid or alkaline product to clean the appliance, as this could damage the surface and interior of the appliance.
Boiling water and benzene could deform or damage plastic components.
resolving failures yourself
7
Failure Cause Solution
The appliance
no longer works
The thermostat knob is on the coldest
position.
Set the thermostat knob to a dierent
temperature to turn on the appliance.
The plug is not in the socket. Insert the plug into the socket.
Temperature in the
appliance is too high
or too low
Wrong setting of the thermostat. Turn the thermostat to a dierent position.
The door of the appliance is opened too
frequently or remains open for too long.
Open the door less often and/or reduce the time
that the door remains open.
A large amount of warm food has been
placed in the appliance in the last 24 hours.
Temporarily set the thermostat to a lower
position.
The ambient temperature is higher or lower
than the temperature indicated in the table
with technical data.
The appliance is intended for operation in an
ambient temperature indicated in the table with
technical data supplied with the appliance.
The appliance is located in direct sunlight
or near a heat source.
Change the location of the appliance according
to the instructions in the instruction manual.
There is water in the lower
section of the appliance.
The opening of the defrost water drain
is clogged.
Clean the opening of the defrost water drain
by means of the skewer.
The interior lighting
flashes 3 times.
The door has been open for too long
or does not close properly.
Check that there is nothing between the door that
prevents it from closing and close the door.
The inner lighting flashes 1
or 2 times.
The temperature knob or sensor
is defective.
Contact customer service.
Unusual or loud noises
The appliance is not level and stable. Level the appliance with the adjustable feet.
The appliance is standing against
something.
Place the appliance in such a way that it is not
standing against anything.
The side of the appliance
is very warm
The condenser is located at the side
of the appliance.
It is normal for the exterior to become warm.
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the appliance.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compressor
(activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences and
flow of cooling liquid).
If the door must be installed the other way around, observe the instructions in section “Reversing the door opening”.
Bekijk gratis de handleiding van Inventum KV1840B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Inventum |
| Model | KV1840B |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 4998 MB |
