Handleiding
Je bekijkt pagina 23 van 52
English • 23
LED LED
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is
blown, it must be replaced by a qualified person to avoid any hazard. Contact the Inventum service
department.
troubleshooting
6
Problem Cause Solution
Appliance is not functioning;
light does not work
Appliance is not plugged in Plug the appliance in the socket
Temperature inside the
larder is too high or too low
Thermostat has been set incorrectly Set the thermostat correctly
Air circulation vents are blocked Clean the ventilation openings
Appliance is excessively noisy Has the appliance been installed correctly? Check the installation
Are the pipes at the back touching or
vibrating?
Check it and move the appliance
forwards
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
reversing the door opening
7
The door of the appliance can be opened on the right or left side. In order to reverse the door opening, please observe the
instructions below. It would be best to do this with two people.
Attention: turn off the thermostat (standby mode) and remove the plug from the socket. Remove all items from the
refrigerator, shelves included, before reversing the door opening of the refrigerator.
• Remove the protective cover on the hinge.
• On the left side of the appliance, remove the protective cover On the right top side, remove the hinge with the three bolts
(do take note of the plastic adapter bushes between the hinge and the door).
• Carefully remove the upper door by moving it towards you and lifting it off the middle hinge. Place this door on a safe
location.
• Remove the middle hinge on the right side by loosening the two bolts and put it aside for the moment. Immediately move
the white protective caps from the left to the right side and place them on the location where the middle hinge was
removed.
• Carefully remove the lower door by moving it towards you and lifting it off the lower hinge. Place this door on a safe location.
• At the bottom side of the door, move the plastic block from the right side to the left side.
• Then tilt the refrigerator backwards by maximum 45°.
• On the left bottom side, remove the adjustable foot and the two bolts.
• On the right bottom side, remove the hinge and the three bolts. Then place the hinge on the left bottom side with the bolts.
• Place the adjustable foot on the right bottom side and re-insert the bolts there as well.
• Place the bottom door against the appliance and make sure the bottom side is properly placed on the bottom hinge.
Make sure the door is straight in relation to the exterior of the refrigerator.
• Mount the middle hinge and accompanying bolts on the left side. Make sure the hinge is placed in the top side of the
bottom door. Use the adapter bushes and tighten the bolts. The bottom door has now been mounted.
• Now place the upper door against the appliance and make sure the bottom side is properly placed on the middle hinge.
• On the left top side, place the hinge with plastic adapter bushes and fasten it with the bolts. Make sure the door is straight
in relation to the exterior of the refrigerator.
• Carefully place the appliance upright again.
• Place the protective cover back on the upper hinge and place the other protective cover where the hinge was before.
• Leave the appliance untouched for 2 to 3 hours before inserting the plug in the socket..
Bekijk gratis de handleiding van Inventum KV1430B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Inventum |
| Model | KV1430B |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 4788 MB |
