Intex PureSpa Bubble Massage 128426 handleiding

Niet gecategoriseerd

Intex

58 pagina's

PDF beschikbaar

Handleiding

244

(244IO) 7.5” X 10.3” ENGLISH 04/19/2023

READ BEFORE YOU START!

NOTE: This quick start guide provides important and useful tips before you start

the setup of your spa. However, it does not address all aspects of spa installation

and use, and you are still required to read, understand, and follow the owner’s

manual for proper installation, maintenance, and safe use of your spa.

• Power: This product draws a minimum of 13 AMPS. Most household circuits are 13 to 16 AMPS. If the

circuit breaker trips, please check that no other appliances or other large loads are on the same circuit as

the spa. Never use an extension cord. Unfold the line cord prior to use. Never place the plug on combustible

materials.

• Water Heating: This heater when properly set up and running will raise the water temperature by 2ºC per

hour PROVIDED the spa cover is properly in place. Depending on the starting temperature of the Spa water

and external air temperature, it will take some time to heat up. If the starting temperature of your tap water

is 22ºC and you wanted to raise it by 16º C to 38ºC, the heating time would be 16ºC/2ºC per hour = 8 hours.

For subsequent use the heating time can be shortened by maintaining an idle temperature in the spa (see

HEATING AND WATER TEMPERATURE section). Be sure to keep the cover on the Spa when not in use.

• RCD: This product is provided with a RCD located at the end of the power cord. The RCD must be tested

before each use. Do NOT use the Spa if the RCD does not function properly. (See owner's manual for

proper testing of RCD instructions).

• Filter Cartridge: Keep the spa water properly sanitized to extend the life of the cartridge. Refer to the

owner’s manual for detailed information on spa water chemistry and balance.

UNFOLDING AND INFLATING YOUR SPA:

 • Whenyouunfoldtheinatablespatubyoumaynoticethesmellofthematerialthatisnormalfor

  anewproductoutofthebox.Itisthereforerecommendedtoinatetheproductandleaveit

  outdoorsforadaytoairandallowthenewproductsmelltodissipatesomewhatbeforellingthe

spa with water.

• Spread the ground cloth with the bubbles facing down over the cleared area where you intend to

setup your spa.

 • Forspaination,familiarizeyourselfwiththespringloadedvalveonthespatubandtheination

  outletonthecontrolboxunittoassurefastandproperination.

Ination outlet tips:

• Thelargerendoftheinationhoseattachestotheairoutletatthebackofthecontrolbaseunit(see

owner’s manual for drawings and further details).

• Toattachtheinationhosetotheairoutlet,ipupthecontrolbasesidecovertorevealtheairblower

inationoutlet.Pulloutthelatchtoopenthecover,insertthehoseadaptorwithhoseandreattachthe

latch to the hose adaptor to secure it in place.

• Wheninationiscomplete,releasethelatch,pullouttheinationhose,andsecurethelatchbackonto

the outlet.

NOTE:

Toavoidover-ination,someairwillescapethroughthebottomair-bubbleoutletofthecontrol

baseduringination.Thisisnormal.

Spring loaded valve tips:

 • Uponremovingthevalvecap,notethespringloadedpininthecenterofthevalve.Forination,

the spring loaded pin should be in the up/raised position (closed position of the valve) as the air

  pressureofthepumpwillpushtheairthroughthevalveduringination.Checkthevalvepinand

  assureitisintheup/raisedpositionbeforestartingination.

• The pin can be pressed down and locked in the recessed position by pressing and turning it 90°

  clockwisewithyournger–thisistheopenpositionofthevalvethatallowstheairtoowout

  freelyandthatisusedfordeation.

SAVE THESE INSTRUCTIONS

244-*IO-R0-2404

English

Bekijk gratis de handleiding van Intex PureSpa Bubble Massage 128426, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.