Intergas Xclusive 36 handleiding
Handleiding
Je bekijkt pagina 47 van 92
47
8.2.1 Filling and venting the central heating system
8.2 Boiler preparation
8.1 Using the control panel
8 OPERATION
2sec
Central heating pressure is too low.
Gently touch and release the white power LED symbol
Gently touch and hold the white power LED symbol for 2 seconds
► Connect the power cable to a 3 amp fused spur supplied via
a type "A" RCD.
► Switch on the power supply to the boiler, A 22 may
momentary appear on the right display; this means that the
internal sensors are being checked. The firmware version
will be momentary shown on the le display.
The boiler enters standby power o mode, characterised by
a line – on the right display and the central heating system
pressure on the le display.
► When the central heating pressure is
lower than 0.5 bar, this will be indicated
by a flashing display (if the boiler is in
central heating demand).
► If the central heating pressure is below
0.2 bar then the demand will no longer
be met.
WARNING
► When an additive is added to the
central heating water, this must be
suitable for the materials used in the
boiler,such as copper, brass, steel,
stainlesssteel, plastic and rubber.
Intergas recommend products
manufactured from :
• Fernox Tel 0330 100 7750
• ADEY Innovations Tel 01242 546 777
• Altecnic Calei Group Tel 01785 218 200
Power on / power o mode.
Bekijk gratis de handleiding van Intergas Xclusive 36, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Xclusive 36 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12726 MB |
