Intergas Xclusive 30 handleiding
Handleiding
Je bekijkt pagina 17 van 92
17
6.2.2 Removing/installing the front panel
► The front cover of the boiler must be removed to perform
various maintenance activities however you must be a
competent Gas Safe registered engineer before carrying out
the following procedure!
► Loosen both screws (1) under the boiler by using a 5 mm
allen key. (They are captive and therefore will not drop out
of the lower housing).
► Slide the front cover (2) upward and then remove it by
pulling it towards you.
1
2
Replacing the room sealed front cover.
To replace the front panel, proceed as follows:
► Position the front panel (3) against the boiler and slide
it downwards until it is correctly connected to the
lower fascia panel.
► Hand tighten screws under the boiler using a 5 mm
allen key (do not over tighten).
3
COMMENT
► The front cover has a rubber seal around
the inner edge sometimes making it
very sti to slide o so please ensure the
boiler is secured to the wall correctly
before attempting this procedure!
CAREFUL
► This is a room sealed cover and therefore
extremely important that it is fitted
correctly, failure to do so could lead to
products of combustion entering the
room / environment where it is situated.
Bekijk gratis de handleiding van Intergas Xclusive 30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Xclusive 30 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 12726 MB |
