Intergas Rapid 32 Plus handleiding
Handleiding
Je bekijkt pagina 40 van 68
Intergas Heating Ltd 40
8. COMMISSIONING
8.1.1 Fill and de-aerate the appliance and the system
WARNING
Connect the appliance to the mains voltage only after
filling and de-aerating!
8.1.1 CH system
WARNING
When an additive is added to the CH water, this should
be suitable for the materials used in the appliance, such
as copper, brass, stainless steel, steel, plastic and
rubber.
1. Fill the system to a maximum pressure of 1 to 2 bar with a cold system.
2. Vent the appliance with the manual air vent (A).
3. Vent the system with the manual air vents on the radiators.
4. Fill up the CH system when the pressure has dropped too low as a result
of the de-aerating.
5. Check all joints for leaks.
6. Fill the siphon with water. See § 7.4 for the filling procedure.
8.1.2 Hot water supply
3. Open the main tap in order to pressurise the hot water part.
4. De-aerate the heat exchanger and the pipe system by opening a hot
water tap.
Leave the tap open until all the air has left the system.
5. Check all joints for leaks.
8.1.3 Gas supply
A. Gas supply purged of air via test point D on gas valve (see illustration
)
B. Connect a suitable gauge to test point D .
Static or standing pressure must be 20mBar.
If 20mBar is not obtained DO NOT proceed with commissioning
until supply is rectified.
C. If static pressure is correct fire the boiler and allow to reach working
temperature.
D. Test working pressure by selecting test program “H”. See section
10.8, High Setting. Working pressure must be 20 mBar + or- 1 mBar.
If working pressure is less than 19mBar the appliance heat output will be
reduced and correct combustion readings may not be obtained. Do not
adjust the air/gas ratio. Correct gas supply to obtain sufficient working
pressure.
Note. The inlet working pressure must be obtained with all other gas
appliances at the property working.
NOTE
The inlet working pressure must be obtained with all
other gas appliances at the property working.
A. Please refer to the Benchmark commissioning Checklist on page 66
Bekijk gratis de handleiding van Intergas Rapid 32 Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Rapid 32 Plus |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10092 MB |
