Intergas Rapid 25 Plus handleiding
Handleiding
Je bekijkt pagina 55 van 68
Intergas Heating Ltd 55
10. FAULTS
10.1 Fault codes
When the service display or the operating panel is flashing, the burner controller has detected a
fault. In case of several faults, the temperature display shows an additional code.
After the fault has been remedied, the burner controller can be restarted by pressing the reset
button on the operating panel.
The following faults are detected and displayed:-
Temperature
display
Description
Possible cause/remedy
10, 11, 12,
13, 14
Sensor fault S1
• Boiler needs venting (manual air vent top left of boiler)
• Check the wires for breaks
• Replace S1
20, 21. 22,
23, 24
Sensor fault S2
• Check the wires for breaks
• Replace S2
0
Sensor fault after self-check
• Check the wires for breaks
• Replace boiler sensor S1 and/or S2
0.0
Pressure sensor fault
• Repressurise central heating circuit via filling loop
• Blocked pressure sensor
1
Temperature too high
• Air in system
• Pump does not run
• Too little circulation in system, radiators closed, pump
setting too low
• Isolation valve closed
2
Exchange S1 and S2
• Check the cable loom
• Replace S1 or S2
4
No flame signal after 4 ignition
attempts
• Gas isolation valve closed, or No gas at meter
• Incorrect ignition distance
• Faulty burner
• Check earth fault
• Gas inlet pressure too low, faulty governor at gas meter
• Gas valve or ignition not powered
• Boiler controller (PCB)
5
No flame signal after 4 restart
attempts
• Condensate discharge blocked
• Check setting of gas valve
• Check earth
6
Flame detection fault
• Replace ignition cable + spark probe
• Replace ignition unit
• Burner control
• Replace burner controller
8
Fan speed incorrect
• Fan rubs against casing
• Wiring between fan and casing
• Check the wires for poor contact (tacho signal)
• Replace fan
27
Shortcut outside sensor
• Replace the outside sensor
29, 30
Relay gas valve defect
• Replace burner controller
Bekijk gratis de handleiding van Intergas Rapid 25 Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Rapid 25 Plus |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10092 MB |
