Intergas Rapid 25 Plus handleiding
Handleiding
Je bekijkt pagina 43 van 68
Intergas Heating Ltd 43
8.3 Setting and adjusting the clock functions
8.3.1 Setting the clock
• Press the button for less than 1 second and repeat this until ‘’24hr clock’’
appears. For adjusting the clock to the correct time press the [+] or [-] button.
Note: Holding the button for more than 1 second will make the clock run fast.
8.3.2 Setting the timer function
• On pressing the button for more than 2 seconds the clock display will flash.
• The time for each on/off shows in the clock display and the service display shows which on 1 and 3 OR off 2 and 4 time is being set.
• Pressing the button again will change between the different on/off switching periods.
The pre-set times are as follows:
Display : [06:00] and [1] → Start first period CH on.
[09:00] and [2] → End first period CH off.
[16:00] and [3] → Start second period CH on.
[22:00] and [4] → End second period CH off.
• By pressing the button the new times will be stored in the boiler controller.
In the service display [P] appears.
• When the clock is in period [1] or [3] (CH ON) the clock symbol LED is on.
• When the clock is in period [2] or [4] (CH not active) the LED is on.
• By pressing the button over 5 seconds the default setting for the switch moments will be restored.
In the service display “F-set” appears.
• By pressing the button the boiler controller will return to the normal situation without storing any changes.
8.4 Additional functions
• Pressing the button for less than 1 second the following additional functions can be activated:
- t-on (temporary on).
The boiler will respond on every CH demand from the room thermostat until the next
switch moment.
- c-on (continuous on).
The boiler will respond on every CH demand from the room thermostat without any
time limit.
- OFF
The boiler will not respond on any CH demand from the room thermostat.
8.5 Shutting down
CAUTION
Drain the appliance and the installation if mains power has
been interrupted and there is a possibility of freezing.
1. Drain the appliance at the drain tap.
2. Drain the installation at the lowest point.
3. Close the main cock for the water supply to the DHW section.
4. Drain the appliance by removing the DHW couplings below the appliance.
Bekijk gratis de handleiding van Intergas Rapid 25 Plus, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Rapid 25 Plus |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10092 MB |
