Handleiding
Je bekijkt pagina 9 van 30
Page 7INF6505/IND6565 Hardware Guide
SETUP
Mounting
This product does not ship with mounting accessories. Only use commercially manufactured mounting accessories which meet this
product's specications and follow the manufacturer installation instructions.
• Only use properly rated wall and stand mounting hardware that meet this product’s specications and follow the manufacturer
installation instructions. The warranty does not cover any damage caused by use of improperly rated mounting hardware or from
improper installation.
• To prevent damage to the screen surface, carefully place your display face-down on a clean, cushioned surface.
• When mounting the display to a wall, metric 8 (12mm) screws must be used. Use spring washers to prevent the screws from
coming loose. In addition, the mounting interface should comply with the UL1678 standard in North America. The mounting means
should be strong enough to bear the weight of the display.
• Do not install the display in places subject to mechanical vibration.
• Do not place the display on an unstable surface, which could result in serious personal injuries and display damage. When
mounting the display to a stand, be sure to following the manufacturer’s instructions. Use only the mounting hardware
recommended by the manufacturer.
• WARNING: This display must be securely attached to the oor/wall per installation instructions. Tipping, shaking, or rocking the
machine may cause injury or death.
• If the display is installed against the wall, maintain a distance of at least 1.98” (5cm) between the display and the wall to provide
adequate ventilation.
• Do not install or use the display near any heat sources such as radiators, heat registers, stoves, or other devices (including
ampliers) that produce heat.
• Do not place the display in direct sunlight, humid, greasy or dusty places or in places where the display may come into contact with
rain, smoke or steam.
Door removal
If desired, the door can be removed for easy access to the front connectors. Follow the instructions below.
IMPORTANT: InFocus is not responsible for door breakage or for improper application of the mylar label.
1) Press the top of the door to release the door.
2) Gently swing the door open, so that the door hinges are visible.
3) Carefully press the right side of the door towards the left to disengage the right hinge, and then slide the door slightly towards
the right to disengage the left hinge.
4) Gently remove the door, and set aside.
5) Remove the back of the mylar label and carefully align the label over the connector panel before applying. If not aligned properly,
the label can interfere with the connection ports.
Bekijk gratis de handleiding van InFocus JTouch INF6505, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InFocus |
| Model | JTouch INF6505 |
| Categorie | Monitor |
| Taal | Nederlands |
| Grootte | 3428 MB |
