Handleiding
Je bekijkt pagina 3 van 44
SPEAKER SIGNAL WIRING
To send signal to the Infinity marine speaker, connect the positive (+) and negative (-) speaker wires to the appropriate
speaker outputs of your source unit or amplifier. Be sure to observe proper polarity.
SPEAKER LED WIRING
To provide power for the LEDs, plug the 24-gauge black (+), blue, green, and red LED wires from the speaker into the
included female connector, then run the wires from the female connector to your compatible 12-volt power source or light
controller (sold separately). If using a separate controller, be sure to connect each wire to the proper output.
If hardwiring the LEDs directly to your power source, you can choose the color of the LEDs by connecting the black wire to
the positive (+) terminal, and the appropriate R, G, and/or B single wire or combination of wires to the negative (-) terminal.
There are 7 possible colors, depending on the wiring configuration you choose:
EN
Kappa 10
9-9/16” (235.6mm)
11-5/8” (295mm)
6-13/32” 162.4mm
4-7/8” (123mm)
R BG
To power source To speaker
Blue
Green
Red
Black
Bekijk gratis de handleiding van Infinity Kappa 6125M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Infinity |
| Model | Kappa 6125M |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 7565 MB |
