Infinity Furion S402 Spot handleiding
Handleiding
Je bekijkt pagina 55 van 64
7. Troubleshooting
This troubleshooting guide contains solutions to problems which can be carried out by an ordinary person. The
device does not contain user-serviceable parts.
Unauthorized modifications to the device will render the warranty void. Such modifications may result in injuries
and material damage.
Refer servicing to instructed or skilled persons. Contact your Highlite International dealer in case the solution is
not described in the table.
Problem Probable cause(s) Solution
The device does not
function at all
No power to the device
• Make sure that the device is connected•
to power supply and the cables are
plugged in
Main fuse is blown
• Replace the fuse (see 8.3.1. Replacing the•
Fuse on page 57)
The device responds
erratically
The factory settings of the device
are changed
• Reset the parameters of the device to the•
default factory settings (see 6.7.2.7. Reset
Function on page 41)
The device does not
respond to DMX control
The controller is not connected • Connect the controller•
The signal is reversed. The 5-pin
DMX OUT of the controller does not
match the DMX IN of the device
• Install a phase-reversing cable between•
the controller and the device
The controller is defective • Try using another controller•
The device responds
erratically to DMX control
Connections are defective
• Examine connections and cables. Correct•
defective connections. Repair or replace
damaged cables
The data link is not terminated with
a 120Ω termination plug
• Insert a termination plug in the DMX OUT•
connector of the last device on the link
Incorrect addressing
• Make sure that the address settings are•
correct
In case of a setup with multiple
devices, one of the devices is
defective and disturbs data
transmission on the link
• To find out the defective device, bypass•
one device at a time until normal
operation is restored
No light or LEDs cut out
intermittently
LEDs are damaged
• Disconnect the device and contact your•
Highlite International dealer, refer to
Corrective Maintenance
The input power parameters of the
device do not match the local AC
voltage and frequency
• Disconnect the device. Make sure that•
the local current, voltage and frequency
match the input voltage, current and
frequency specified on the information
label on the device
No wireless connection
The device is not connected to the
transmitter, when the W-DMX
indicator on the display of the
device is gray.
• Create a wireless connection, refer to•
Wireless Connection (see 5.4. Wireless
Connection)
The device is trying to connect to
the transmitter, when the W-DMX
indicator on the display is blinking
quickly. This will take 30 seconds.
• Create a wireless connection, refer to•
Wireless Connection (see 5.4. Wireless
Connection)
This device cannot receive a
wireless DMX signal and a DMX
cable signal at the same time.
• Remove the DMX cable•
54
c
Product code: 41450
Furion S402 Spot
Bekijk gratis de handleiding van Infinity Furion S402 Spot, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Infinity |
| Model | Furion S402 Spot |
| Categorie | Verlichting |
| Taal | Nederlands |
| Grootte | 8946 MB |
