Handleiding
Je bekijkt pagina 2 van 32
appliance does not damage the power cable - risk of fire or
electrical shock. Only activate the appliance when the
installation has been completed.
WARNING: Modification of the appliance and its
method of installation are essential in order to use the
appliance safely and correctly in all the additional countries.
Use pressure regulators suitable for the gas pressure
indicated in the instruction.
The room must be equipped with an air extraction
system that expels any combustion fumes.
The room must also allow proper air circulation, as air is
needed for combustion to occur normally. The flow of air
must not be less than 2 m
3
/h per kW of installed power.
The air circulation system may take air directly from the
outside by means of a pipe with an inner cross section of
at least 100 cm
2
; the opening must not be vulnerable to
any type of blockages.
The system can also provide the air needed for
combustion indirectly, i.e. from adjacent rooms fitted with
air circulation tubes as described above. However, these
rooms must not be communal rooms, bedrooms or
rooms that may present a fire hazard.
Liquid petroleum gas sinks to the floor as it is heavier
than air. Therefore, rooms containing LPG cylinders must
also be equipped with vents to allow gas to escape in the
event of a leak. As a result LPG cylinders, whether partially
or completely full, must not be installed or stored in rooms
or storage areas that are below ground level (cellars, etc.).
It is advisable to keep only the cylinder being used in the
room, positioned so that it is not subject to heat produced
by external sources (ovens, fireplaces, stoves, etc. ) which
could raise the temperature of the cylinder above 50°C.
Should you experience difficulty in turning the burners knobs, please contact After
Sales Service for replacement of the burner tap if found to be faulty.
The openings used for the ventilation and dispersion of heat must never be covered.
Carry out all cabinet cutting works before fitting the
appliance in the furniture and remove all wood chips and
sawdust.
If the appliance is not installed above an oven, a
separator panel (not included) must be installed in the
compartment under the appliance.
GAS CONNECTION
WARNING: Prior to installation, ensure that the local
distribution conditions (type of gas and gas pressure) and
the adjustment of the appliance are compatible.
Check that the pressure of the gas supply is consistent
with the values indicated in “Burner and nozzle
specifications” table.
WARNING: The configuration conditions for this
appliance are stated on the label (or data plate).
WARNING: This appliance is not connected to a
combustion products evacuation device. It must be
installed and connected in accordance with current
installation regulations. Particular attention must be paid
to the relevant requirements regarding ventilation.
If the appliances is connected to liquid gas, the
regulation screw must be fasted as tightly as possible.
IMPORTANT: When the gas cylinder or gas container is
installed, it must be properly settled (vertical orientation).
WARNING: This operation must be performed by a
qualified technician.
Use only flexible or rigid metal hose for gas connection.
Connection with a rigid pipe (copper or steel)
Connection to the gas system must be carried out in such
a way as not to place any strain of any kind on the appliance.
There is an adjustable L-shaped pipe fitting on the
appliance supply ramp and this is fitted with a seal in order
to prevent leaks. The seal must always be replaced after
rotating the pipe fitting (the seal is provided with the
appliance). The gas supply pipe fitting is a threaded 1/2
gas cylindrical male attachment.
Connecting a flexible jointless stainless steel pipe to a
threaded attachment. The gas supply pipe fitting is a
threaded 1/2 gas cylindrical male attachment. These pipes
must be installed so that they are never longer than 2000
mm when fully extended. Once connection has been
carried out, make sure that the flexible metal pipe does
not touch any moving parts and is not compressed. Only
use pipes and seals that comply with current National
regulations.
IMPORTANT: If a stainless steel hose is used, it must be
installed so as not touch any mobile part of the furniture
(e.g. drawer). It must pass through an area where there are
no obstructions and where it is possible to inspect it on all
its length.
The appliance should be connected to the main gas
supply or to gas cylinder in compliance with the current
national regulations. Before making the connection, make
sure that the appliance is compatible with the gas supply
you wish to use. If this is not the case, follow the instructions
indicated in the paragraph “Adapting to different types of
gas”.
After connection to the gas supply, check for leaks with
soapy water. Light up the burners and turn the knobs
from maximum position 1* to minimum position 2* to
check flame stability.
ADAPTING TO DIFFERENT TYPES OF GAS
(This operation needs to be carried out by a qualified
technician).
In order to adapt the appliance to a type of gas other
than the type for which it was manufactured (indicated on
the rating label), follow the dedicated steps provided after
installation drawings.
ELECTRICAL WARNINGS
IMPORTANT: Information about current and voltage
consumption is provided on the rating plate.
It must be possible to disconnect the appliance from
the power supply by unplugging it if plug is accessible, or
by a multi-pole switch installed upstream of the socket in
accordance with the wiring rules and the appliance must
be earthed in conformity with national electrical safety
standards.
Bekijk gratis de handleiding van Indesit THP 641 IX/I, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Indesit |
| Model | THP 641 IX/I |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5597 MB |
Caratteristiche Prodotto
| Apparaatplaatsing | Ingebouwd |
| Soort bediening | Draaiknop |
| Kleur van het product | Roestvrijstaal |
| Ingebouwd display | Nee |
| Timer | Nee |
