Handleiding
Je bekijkt pagina 4 van 13
4 / 13
resting on the oor, adjusting them as required,
and check that the appliance is perfectly level
using a spirit level. Wait at least two hours before
switching the appliance on, to ensure that the
refrigerant circuit is fully ecient.
WARNING: When positioning the appliance,
ensure the supply cord is not trapped or
damaged.
WARNING: To avoid a hazard due to instability,
positioning or xing of the appliance must be
done in accordance with the manufacturer
instructions.
It's forbidden to place the refrigerator in such
way that the metal hose of gas stove, metal gas
or water pipes, or electrical wires are in contact
with the refrigerator back wall (condenser coil).
To guarantee adequate ventilation, leave a
space on both sides and above the appliance.
The distance between the rear of the appliance
and the wall behind the appliance should be 50
mm, to avoid access to hot surfaces. A reduction
of this space will increase the Energy consumption
of product.
Please remove the power cord from condenser
hook during installation before connecting
product to power supply.
ELECTRICAL WARNINGS
It must be possible to disconnect the appliance
from the power supply by unplugging it if plug is
accessible, or by a multi-pole switch installed
upstream of the socket in accordance with the
wiring rules and the appliance must be earthed
in conformity with national electrical safety
standards.
Do not use extension leads, multiple sockets
or adapters. The electrical components must not
be accessible to the user after installation. Do not
use the appliance when you are wet or barefoot.
Do not operate this appliance if it has a damaged
power cable or plug, if it is not working properly,
or if it has been damaged or dropped.
If the supply cord is damaged, it must be
replaced with an identical one by the
manufacturer, its service agent or similarly
qualied persons in order to avoid a hazard - risk
of electrical shock.
WARNING: Do not locate multiple portable
socket-outlets or portable power supplies at the
rear of the appliance.
CLEANING AND MAINTENANCE
WARNING: Ensure that the appliance is
switched o and disconnected from the power
supply before performing any maintenance
operation. To avoid risk of personal injury use
protective gloves (risk of laceration) and safety
shoes (risk of contusion); be sure to handle by
two persons (reduce load); never use steam
cleaning equipment (risk of electric shock). Non-
professional repairs not authorised by the
manufacturer could result in a risk to health and
safety, for which the manufacturer cannot be
held liable. Any defect or damage caused from
non-professional repairs or maintenance will not
be covered by the guarantee, the terms of which
are outlined in the document delivered with the
unit.
Do not use abrasive or harsh cleaners such as
window sprays, scouring cleansers, ammable
uids, cleaning waxes, concentrated detergents,
bleaches or cleansers containing petroleum
products on plastic parts, interior and door liners
or gaskets. Do not use paper towels, scouring
pads, or other harsh cleaning tools.
This refrigerating appliance is not intended to be
used as a built-in appliance.
Doors and lids of the refrigeration appliance
should be removed before disposal in the landll,
to avoid children or animals getting trapped
inside.
Recommended setting:
• Refrigerator compartment: +4°C or MED
• Freezer compartment: -18°C or -20°C
To optimise freezing speed and get more storage
space, the freezer compartment can be used
without the freezer drawers and the food can be
placed directly on the bottom of the
compartment. The quantity of fresh food that
can be frozen in a specic time period is indicated
on the rating plate.
Load limits are determined by baskets, aps,
drawers, shelves etc. Make sure that these
components can still close easily after loading. To
avoid food waste, please refer to the
recommended setting and storage times found
in the online user manual.
Fill 2/3 of the ice tray with water and put it back
in the freezer compartment. Do not, under any
circumstances, use sharp or pointed objects to
remove the ice. The model information can be
retrieved using the QR-Code indicated on the
energy label. The label also includes the model
identier that can be used to consult the https://
eprel.ec.europa.eu database portal.
Policies, standard documentation, ordering
spare parts and additional product information
can be found at this address:
https : / / parts - selfservice . europeanappliances . c
om
Bekijk gratis de handleiding van Indesit INKF 8251 S4UK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Indesit |
| Model | INKF 8251 S4UK |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 1693 MB |
