Indesit BTW S50400 handleiding
Handleiding
Je bekijkt pagina 4 van 48
TROUBLESHOOTING
The washing machine may sometimes not work properly for certain reasons. Before calling the After-Sales Service, it is recommended to check to see if
the problem can be easily resolved using the following list.
Anomalies: Possible causes / Solution:
The washing machine does not turn on
and/ or programme does not start
• The plug is not inserted into the electrical outlet, or not enough to make contact.
• There has been a power failure.
• Lid is not properly closed.
• The washing machine switched o automatically to save energy, before programme start or
after programme end. To switch on the washing machine, turn the programme selector rst to
“O/O” and then to the desired programme again.
The wash cycle does not start.
• The “Start/Pause” button has not been pressed.
• The water tap is not open.
• A “Start delay” has been set.
Appliance stops during the
programme, and the
“Start/Pause” light blinks
• Programme has been changed - reselect desired programme and press “Start/Pause” .
Appliance vibrates
• The washing machine is not level.
• The transport bracket has not been removed; before using the washing machine, the transport
bracket must be removed.
Final spin results are poor. The laundry
is still very wet. “Spin” indicator blinks,
or the spin speed on the display blinks,
or the spin speed indicator blinks after
the end of the programme - depending
on the model
• Unbalance of the laundry load during spinning prevented the spin phase to avoid damages on
the washing machine. This is why the laundry is still very wet. Reason for unbalance can be:
small laundry loads (consisting of only few quite big or absorbent items, e.g. towels), or big/
heavy laundry items.
• If possible avoid small laundry loads.
• “Spin speed” button has been set to a low spin speed.
The machine is indicating an error code
(e.g. F-02, F-..) and/or “Service”
indicator lights up
• Shut o the machine, disconnect the plug from the outlet, and wait about 1 minute before
turning it back on.
• If the problem persists, call the After-sales service.
“Clean lter” indicator lights up
• Waste water is not pumped out.
• Clean the water lter
“Water tap closed” indicator lights up
• Appliance has no or insucient water supply.
XXXXX
Regulatory documentation, standard documentation, ordering spare parts and other product information can be
found:
• By visiting our website docs .indesit. eu and parts - selfservice .indesit. com
• Using QR Code
• Alternatively, contact our After-Sales Service (See phone number in the warranty booklet). When contacting our
After-sales Service, please state the codes provided on your product’s identication plate.
For User Repair & Maintenance Information visit www.indesit.com
The model information can be retrieved using the QR-Code reported in the energy label. The label also includes the model
identier that can be used to consult the portal of the registry at https://eprel.ec.europa.eu
Bekijk gratis de handleiding van Indesit BTW S50400, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Indesit |
| Model | BTW S50400 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 9873 MB |
