Handleiding
Je bekijkt pagina 17 van 28
17
To keep your dryer operating eciently and safely,
regular cleaning and care are essential. Follow the
steps below to maintain your appliance and extend its
lifespan.
Cleaning the Dryer
Regular cleaning helps keep your dryer running
eciently and looking its best. Always follow safety
precautions when cleaning any part of the appliance.
WARNING:
• Always disconnect the power cord before cleaning.
• Use only a soft cloth dampened with clean water.
• Do not use solvents, abrasive cleaners, glass cleaners,
or general-purpose cleaners, as these may damage
plastic surfaces or other components.
• It is recommended to wear gloves during cleaning to
protect your hands.
How to Clean:
• Prepare a soft cloth dampened with clean water
(not dripping wet).
• Wipe down the outside of the appliance, including the
control panel.
• Open the dryer door and clean the inside of the door
window, removing any lint or smudges.
• Clean the door seal (rubber gasket) around the drum
opening to remove lint and moisture.
• Gently wipe the humidity sensor located inside
the drum, using only a damp cloth.
• Remove all filters (door filter and lower filter), then
wipe around the filter housing and airflow openings.
• Before using the dryer again, dry all cleaned areas
thoroughly with a soft, dry cloth.
TIP: Clean the inside of the door and door seal weekly
to avoid build-up of detergent residue or fabric softener.
Emptying the Water Container
After each cycle, the dryer collects moisture in the
internal water container. This must be emptied to avoid
interruptions.
If you have installed the Optional Bypass Drain Hose,
you can skip this step. Refer to page 7 for drain hose
setup instructions.
To empty the water container:
• Gently pull out the water container using both hands,
keeping it level to avoid spills.
• Tilt the container over a sink or basin to pour out the
collected water (condensate).
• Once empty, carefully slide the container back
into place.
WARNING:
• Always empty the water container after each use.
• If the container becomes full during operation, the
dryer will pause automatically and the display will
show “FUL”.
• After emptying the container, press the Start/Pause
button to resume drying.
• Do not drink the water collected in the container.
• Never run the dryer without the water container
installed.
Cleaning & Maintenance
MAINTENANCE
21
Empty the water container
Clean the filter door
1. Pull out and hold the water container
with two hands.
2. Tilt the water container, pour out the
condensate water into the basin.
3. Install the
water container.
Clean the filters
Cleaning and Care
This dryer has a primary door lint filter and a base filter in front of the heat exchanger
for additional protection. Make sure you clean the door filter after each cycle.
The base filter need to be cleaned after each fifth drying programme.
1. Open the door.
2. Take out the filter.
3. Open the filter and remove the fluff on
the filter, You can clean it in water.
4. Dry the filter thoroughly before
installing it back.
door
running
door
• Take notice of the correct orientation
before to insert the door filter.
Note!
Door Filter
• Empty the water container after each use. Once the water container is filled
completely, the programme will be paused and the " " icon will light. After
the container is emptied, the dryer can be restarted by pressing
【Start/Pause】button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.
Warning!
！！
MAINTENANCE
21
Empty the water container
Clean the filter door
1. Pull out and hold the water container
with two hands.
2. Tilt the water container, pour out the
condensate water into the basin.
3. Install the
water container.
Clean the filters
Cleaning and Care
This dryer has a primary door lint filter and a base filter in front of the heat exchanger
for additional protection. Make sure you clean the door filter after each cycle.
The base filter need to be cleaned after each fifth drying programme.
1. Open the door.
2. Take out the filter.
3. Open the filter and remove the fluff on
the filter, You can clean it in water.
4. Dry the filter thoroughly before
installing it back.
door
running
door
• Take notice of the correct orientation
before to insert the door filter.
Note!
Door Filter
• Empty the water container after each use. Once the water container is filled
completely, the programme will be paused and the " " icon will light. After
the container is emptied, the dryer can be restarted by pressing
【Start/Pause】button.
• Do not drink the condensate water.
• Do not use the dryer without the water container.
Warning!
！！
Bekijk gratis de handleiding van InAlto IHPD800S2W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InAlto |
| Model | IHPD800S2W |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 2298 MB |
