Handleiding
Je bekijkt pagina 8 van 26
08
Connection of the Appliance
Connecting the appropriate power supply
(terminal board/connector block)
• Using a screwdriver, prize open tabs of the Terminal
board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw heads,
using brass ‘bridge’ for single phase supply.
• Fasten cable clamp and close the cover of the
terminal board.
• The AC power supply should be 220-240 V, 50/60 Hz. The
minimum 45A fuse, or at least 45A a distribution circuit
breaker.
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum contact
opening of 3 mm, between the appliance and the mains
fuse box. The circuit breaker should be sized according to
the load and should comply with current regulations (the
earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not
reach a temperature of more than 50ºC above ambient
temperature (or room temperature), anywhere along its
length. Before switching the fuse ON within the meter-box,
please check:
• Earth continuity. The electrical safety of this appliance
can only be guaranteed if the cooker is correctly installed
and earthed, in compliance with regulations on electrical
installations.
• The electrical capacity of the system and sockets will
support the maximum power of the appliance,
as indicated on the data plate.
Installation Instructions (Continued)
Bekijk gratis de handleiding van InAlto I54DOCES, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InAlto |
| Model | I54DOCES |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2472 MB |
