Handleiding
Je bekijkt pagina 6 van 24
06
Prior to Beginning Installation
• Make sure to check the condition of the appliance
after unpacking it. Do not continue with installation
if it has been damaged during transport.
• Safe operation of this appliance can only guaranteed
if it has been professionally assembled and installed
in accordance with these instructions by a qualified
technician. The individual who assembled and
installed the appliance is liable for damages or faults
resulting from an incorrect assembly or installation.
• Installation and maintenance must be carried out
by an authorised service agent or similarly qualified
technician.
• Ensure power to the appliance has been shut o
before carrying out any installation or maintenance.
• It is vital that the appliance is properly earthed before
completing the installation process.
• If a rangehood is to be fitted, follow the installation
guidelines supplied with the rangehood.
General Installation Warnings
• The appliance must be installed by a licensed
electrician.
• Please never try to modify or repair the appliance
by yourself.
• The appliance should be installed with
adequate ventilation.
• A certificate of compliance must be supplied by the
Installer and is to be kept by the customer.
• The packing materials must be removed before you
install the cooker.
• You must follow the installation instructions in
this booklet.
• The surrounding kitchen cabinets must be able to
withstand 85ºC.
• The appliance must not be installed in a corner. It
must be installed at least 100mm from the side wall.
• Do not obstruct the vents, openings and air spaces on
the appliance.
• The anti-tilt plate must be installed to avoid
accidental tipping.
• The stabilising bolt must be installed to avoid
accidental moving.
• You must not pull or lift the appliance by the door
handles.
• A suitable isolating switch providing full
disconnection from the mains power supply must be
incorporated in the permanent wiring.
The switch must be mounted and positioned to
comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and
provide a 3 mm air gap contactseparation in all poles
(or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
The isolating switch will be easily accessible to the
customer with the oven installed.
• If the supply cord or cable is damaged, it must be
replaced by an approved service agent or a similarly
qualified person in order to avoid a hazard.
• According to the electrical safety regulations, the
appliance must be properly earthed.
Connection of the Appliance
Connecting the appropriate power supply (terminal
board/connector block)
• Using a screwdriver, prize open tabs of the Terminal
board cover.
• Remove the wire clamp screw.
• Fasten the wires beneath the corresponding screw
heads, using brass ‘bridge’ for single phase supply.
• Fasten cable clamp and close the cover of the
terminal board.
• The AC power supply should be 220-240 V, 50/60 Hz.
The minimum 45A fuse, or at least 45A a distribution
circuit breaker.
Connecting the supply cable to the mains
Install an approved circuit breaker with a minimum
contact opening of 3 mm, between the appliance and
the mains fuse box. The circuit breaker should be sized
according to the load and should comply with current
regulations (the earth wire should not be interrupted by
the circuit breaker).
The supply cable should be positioned so that it does not
reach a temperature of more than 50ºC above ambient
temperature (or room temperature), anywhere along its
length. Before switching the fuse ON within the meter-
box, please check:
• Earth continuity. The electrical safety of this
appliance can only be guaranteed if the cooker is
correctly installed and earthed, in compliance with
regulations on electrical installations.
• The electrical capacity of the system and sockets will
support the maximum power of the appliance,
as indicated on the data plate.
Installation Instructions
Bekijk gratis de handleiding van InAlto I50SEW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InAlto |
| Model | I50SEW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 2271 MB |
