Imarflex IB-645GS handleiding

Handleiding

12/ 2

Afdrukken

Je bekijkt pagina 2 van 2

Lid/Center Lid

Wash in warm soapy water. Rinse by a running water and dry. Reassemble before use.

Container and Blade Assembly:

Method #1

- After use, add warm water and a splash of vinegar to blender jar. Turn ON and let the

blender work the liquid for about a minute. Pour out, rinse the blender jar well.

Method #2

- Fill the blender jar half way with warm water, add a small amount of liquid dish detergent and

turn the unit ON for about 30 seconds. Repeat if needed. Rinse well.

Method #3

- If blender was left sitting until there is dried, crusty food bits inside: fill with warm, soapy

water (or vinegar water) and let sit for about 30 to 60 seconds. Empty water to about half

and then blends for 30 second intervals until clean.

1. Turn OFF the unit and wait for the blade and motor to stop.

2. Always unplug the unit after every use.

3. Remove the blade assembly by turning it clockwise.

4. Wash the rubber packing, blade and jar support with soap and water.

5. Turn the plastic jar upside down to remove excess water.

6. Wipe the plastic jar and blade with soft cloth to dry. Make sure to reassemble the unit

properly before storing it.

7. Never leave food inside the blender jar for a long period of time.

8. Store the blender on a dry cool place.

NOTE: NEVER ALLOW THE BOTTOM OF THE BLADE TO GET WET.

TROUBLE SHOOTING:

REMINDER: Please do not forget to fill up and send the warranty card with receipt to our

email addressimarflexfb@evergoodinc.com

Distributed By: Evergood Unlimited Corp.

901 G.Masangkay St., Manila

Made in China

PROBLEM

CAUSE

SOLUTION

Motor not

working

1. Convenience

outlet is not

working.

2. Damage on the

unit

1. Check the outlet where the

unit is plug in if it is working.

2. Check for any damage.

3. Bring the unit to the nearest

Authorized Imarflex Service

Center

Motor stop

during

operation

1. Overload

protection

activated

1. Unplug and let the unit rest

for at least 1 minute

Smoke and

burnt smell

occurred

1. Unit is use for the

first time

1. Its normal for the first use

Leak on

the bottom

of the jar

1. Rubber packing is

not properly

installed

2. Rubber was

damaged

1. Turn OFF the unit. Remove

the jar and check the rubber.

Reassemble the unit.

2. Replace the rubber with the

new one.

3. Bring the unit to the nearest

Authorized Imarflex Service

Center.

Attachment

not

functioning

1. Not properly install

1. Turn off the unit and

check the assembly

12/ 2

Bekijk gratis de handleiding van Imarflex IB-645GS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Blender