IKEA TVÄTTAD 204.940.72 handleiding
Handleiding
Je bekijkt pagina 27 van 52
3. If desired, set one or more options by
touching the related buttons. The related
indicators illuminate.
If a selection is not possible an
acoustic signal sounds and the
display shows .
Starting a programme
Touch the Start/Pause button to start the
programme. The related indicator stops
ashing and stays on. It is not possible to
start the programme when the indicator of
the button is o and doesn't ash (e.g.
programme knob on a wrong position).
The programme starts, the door is locked.
The display shows the indicator
.
The drain pump can operate
shortly before the appliance lls
water.
Starting a programme with the delay
start
1. 1. Touch the Delay Start button
repeatedly until the display shows the
desired delay time. On the display the
indicator shows
2. Touch the Start/Pause button. The
appliance door locks and starts the
countdown of the delay start. The display
shows the indicator
.
When the countdown is completed, the
programme starts automatically.
Cancelling the delay start after the
countdown has started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator ashes.
2. Touch the Delay Start
button
repeatedly until the display shows and
the indicator
goes o.
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after the
countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator ashes.
2. Touch the Delay Start
button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause
button again
to start the new countdown.
The AutoAjust System load detection
The programme duration in the
display is referred to a medium/
high load.
After touching the Start/Pause button,
the maximum declared load indicator goes
o, the AutoAjust System starts the laundry
load detection:
1. The appliance detects the load in the rst
30 seconds. In the programmes where
FlexTime is available, during this phase
the FlexTime bars
placed below the
time digits play a simple animation. The
drum rotates shortly.
2. The programme duration could be
adjusted accordingly and could increase
or decrease. After further 30 seconds,
the water lling starts.
At the end of the load detection, in case of
drum overload, the indicator
is
ashing in the display:
In this case, for 30 seconds, it is possible to
pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause
button to start the
programme again. The AutoAdjust phase
can be repeated up to three times (see point
1).
Important! If the laundry amount will not be
reduced, the washing programme starts
ENGLISH
27
Bekijk gratis de handleiding van IKEA TVÄTTAD 204.940.72, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IKEA |
| Model | TVÄTTAD 204.940.72 |
| Categorie | Wasmachine |
| Taal | Nederlands |
| Grootte | 4661 MB |
