Handleiding
Je bekijkt pagina 10 van 40
10
Factory reset
If your speaker is not working properly, try
to factory reset it. Press and hold the System
button (4) for 8 seconds until the LED status
light has stopped blinking red. You will now
have to pair it with your device again.
Safety and important notice
WARNING:
• Risk of overheating! Never install the
product in a conned space. Always leave a
space of at least 5 mm around the product
for ventilation. Ensure curtains or other
objects never cover the ventilation slots on
the product.
• Never place the product near open ames
or other heat sources, including direct
sunlight.
• Only use this product indoors. The device
shall not be exposed to dripping or
splashing, and no objects lled with liquids,
such as vases, shall be placed on the
apparatus.
• Never place this product on other electrical
equipment.
• If the power supply cord is damaged,
replace it with a new cord which is type-
approved for your country.
• No open ame sources, such as lit candles,
should be placed on the device.
• The mains plug or an appliance coupler
is to be used as a disconnect device, the
disconnect device shall remain readily
operable.
IMPORTANT
• Do not leave the speaker in direct sunlight
or near any heat source, as it may overheat.
• Do not subject the speaker to wet, moist or
excessively dusty environments, as this may
cause damage.
• The range between the speaker and the
receiver is measured in open air.
• Dierent building materials and placement
of the units can aect the wireless
connectivity range.
• Too high volume can damage your hearing.
• Do not touch the acoustic components.
• Do not use the product as a shelf or stand.
• For important markings, check the bottom
side of the product.
2. Make sure your device is paired via
Bluetooth to your NATTBAD speaker.
3. Make sure the Spotify app is open. This will
only be needed upon the rst use.
4. Press the Spotify Tap™ -button (3) to start
music.
From now on, whenever you quickly press
the Spotify Tap™ -button (3), the music
resumes anytime your device is paired and
in range.
Changing music (Spotify Tap™)
While music is playing, press the button
(3) again to change what's playing to a
recommended track.
Connecting more speakers together (multi-
speaker mode)
This speaker has a multi-speaker mode
which means it can be connected with all our
other speakers that have the same mode, so
you can enjoy the same music from several
speakers.
1. Connect your device to one of the speakers
via Bluetooth.
2. Press and hold the Sound knob (2) on the
other speaker you want to connect. The LED
status light (1) will double blink white, and a
conrmation sound will be audible from the
speakers. Repeat this for every new speaker
you want to add to your multi-speaker
mode.
Disconnecting speakers from multi-speaker
mode
Press and hold the System button (4) for more
than 1.5 seconds on the speaker you want to
disconnect in order to enter the pairing mode
on that speaker.
Unpairing Bluetooth devices
If you want to connect another device to your
speaker, simply turn o Bluetooth on the
device you had paired. The speaker should
go into pairing mode automatically. If not,
press and hold the system button (4) to enter
pairing mode.
Bekijk gratis de handleiding van IKEA NATTBAD 706.048.84, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IKEA |
| Model | NATTBAD 706.048.84 |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 5908 MB |
