Handleiding
Je bekijkt pagina 26 van 128
Troubleshooting
Error code
Description Possible causes of the error Solution
“Acoustic signal
upon ignition. No
error code dis-
played”
The hood com-
mand does not
work
LIN cable damaged or badly con-
nected to the hood electronic
board
Check the connection. If the error persists, con-
tact the After-Sales Service.
ER03
Hob switches off
after 10 sec.
Continuous key activation detec-
ted.
Water or pan placed on the con-
trol panel.
Remove water or pan from the ceramic glass
surface and control panel.
ER21
Hob switches off.
The internal temperature of elec-
tronic parts is too high.
Let the hob cool down.
Please check if the hob has sufficient ventilation.
If the error persists, please contact the After-Sales
Service.
E2
Corresponding
cooking area
switches off.
Empty or unsuitable pan.
Pan or ceramic glass surface
temperature too high.
Electronic component temperat-
ure too high.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
E3
Corresponding
cooking area
switches off.
Unsuitable pan.
The pan is losing its magnetic
properties and may damage the
induction hob.
Use a suitable pan.
The error is automatically cancelled after 8
seconds and the cooking area can be used
again.
If any other errors occur, the pan must be
changed.
If the error persists, please contact the After-Sales
Service.
E6
Hob does not
switch on.
Power supply voltage and/or fre-
quency is out of range.
Check mains voltage and/or frequency.
If necessary, contact the After-Sales Service.
E8
Cooking areas
are turned off.
Fan fault.
Fan blocked by dust or fibres.
Clean and remove foreign bodies from the fan.
If the error persists, please contact the After-Sales
Service.
E4 / E5 / E7 / E9 /
ER20 / ER22 / ER31 /
ER36 / ER42 / ER47 /
EA / EH
Disconnect the hob from the power supply.
Wait a few seconds, then reconnect the hob to the power supply.
If the problem persists, call the After Sales Service and specify the error code that appears on the dis-
play.
Fan not working Cable fan unplugged Plug the cable
Hood not working Hood power cable disconnected
Reconnect the hood power cable
found towards the front right un-
derneath the hob.
If there is a fault try to solve the problem
by following the troubleshooting guidelines.
If the problem cannot be solved contact the
After-Sales Service. You can find a full list of
IKEA appointed contacts at the end of this
user manual.
If you operate the appliance incorrectly,
or the installation was not carried out by an
authorised installer, the visit from the After-
Sales Service technician or dealer will not be
free of charge, even during the warranty
period.
Maintenance and repair
• Make sure that maintenance on electrical
components is only carried out by the man-
ufacturer or by the service technicians.
• Make sure that damaged cables are only
replaced by the manufacturer or by the ser-
vice technicians.
ENGLISH 26
Bekijk gratis de handleiding van IKEA FÖRDELAKTIG 405.158.65, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IKEA |
| Model | FÖRDELAKTIG 405.158.65 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 11874 MB |
