IK Multimedia iLoud Micro Monitor Pro handleiding
Handleiding
Je bekijkt pagina 9 van 72
iLoud Micro Monitor Pro
Installation and setup
9
Installation and setup
We recommend using high-quality audio cables to guarantee optimal performance. It is also important to ensure
that the speakers stand firmly on a solid surface. Please note that the loudspeakers will need a few days to
achieve optimal sonic performance.
1. Make sure that the volume control of iLoud Micro Monitor Pro is set to minimum.
2. Position the speakers according to your needs. For a stereo setup the speakers should be positioned to
form an equilateral triangle with your listening position.
3. Adjust the speaker’s vertical alignment. The tweeters should be at the same height as your ears. If the
speakers are positioned lower than your ears (for example, on a desk), use the tiltable feet to tilt the speakers
upward and aim the tweeters at your ears.
4. Connect the audio input source to XLR or RCA input connector of iLoud Micro Monitor Pro.
5. Connect the power cord. The front LED will illuminate steady white after a short delay.
6. Turn your audio playback system on (Mixing console, Audio interface, etc.). Set the volume knob of iLoud
Micro Monitor Pro to 0 dB (center detent). This is the reference position for the SPL-calibrated values in the
specs. Adjust the volume control to a higher or lower position only if needed or only in case you require
different levels between the speakers.
7. Adjust the speaker response with the dedicated controls on the rear panel if needed.
8. Optionally, you can perform a speaker calibration to perfectly fit your iLoud Micro Monitor Pro into your
acoustic environment. An ARC MEMS calibration microphone is required for this. For more information, refer
to the paragraph “Custom ARC calibration”.
Note: Before plugging in and turning on, remember the “last on, first off” rule for powered speakers.
When powering up your system, be sure that all the wires are connected. Then, turn on your mixer/interface and
any other outboard gear, and lastly, turn on your iLoud Micro Monitor Pro.
When powering down, turn off your iLoud Micro Monitor Pro first, followed by your mixer/interface and outboard
gear.
Bekijk gratis de handleiding van IK Multimedia iLoud Micro Monitor Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IK Multimedia |
| Model | iLoud Micro Monitor Pro |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 6360 MB |