IFM SUH420 handleiding
Handleiding
Je bekijkt pagina 23 van 39
Ultrasonic flow meter SUH1xx SUH22x SUH3xx SUH42x SUH5xx SUH6xx SUH7xx SUH8xx
23
MEWMAW AEPASP
-120Q [% MEW]
[°C]T -48 -40 120 144 156
-130
-52
[°F]-54,4 -40 248 291,2 312,8-61,6
120100-100 130
4
3,8
3,5FOU=OFF
20
20,5
21,5
[mA]
FOU=On
cr.UL UL OL cr.OL
2
3
4
1
B
A
Fig.11: Characteristic of the analogue output according to IEC 60947-5-7.
A: Analogue signal MAW: Initial value of the measuring range
B: Process value MEW: Final value of the measuring range
1: Detection range ASP: Analogue start point
2: Display range AEP: Analogue end point
3: Measuring range UL: Below the display range
4: Scaled measuring range cr.UL: Below the detection range
Q: Flow OL: Above the display range
T: Temperature cr.OL: Above the detection range
The analogue signal in case of a fault can be set via the parameter [FOU]: Error behaviour of
the outputs (Ò/25).
Parameters to be set:
[ou2] = [I/4…20mA], [ASP2]; [AEP2]
9.2.5 Frequency signal
The device provides a frequency signal proportional to the process value.
The frequency signal is adjustable:
• [FrP1] defines the frequency signal in Hz that is provided when the upper measured value is
reached.
Setting range: 1 Hz…10 kHz.
The measuring range is scalable:
• [FSP1] defines the lower measured value from which a frequency signal is provided.
Bekijk gratis de handleiding van IFM SUH420, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | SUH420 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3147 MB |
