IFM CR2042 handleiding
Handleiding
Je bekijkt pagina 9 van 132
UK
ioControl
9
6 Electrical connection
► Disconnect the plant from the mains supply before installation, if
necessary, also disconnect any independently supplied output load
circuits�
► Observe the national and international regulations for the installation of
electrical equipment�
► Observe the requirements according to IEC EN 60204�
Accessible surfaces of the device are insulated from the circuits with basic
insulation to IEC 61010-1 (secondary circuit with max� 32 V DC, supplied from
main circuit up to 300 V of overvoltage category II)�
The external wiring has to be carried out in a way that ensures the required
separation from other circuits�
6.1 Wiring
Wiring (→ 9 Technical data)
The connection terminals may only be supplied with the signals indicated in
the technical data / on the device label and only the approved accessories
from ifm electronic gmbh may be connected�
The device is designed for supply via a mobile on-board system (12/24 V
DC nominal voltage) or SELV/PELV according to the technical data and
national regulations� The supply is directly transferred to the connected
sensors/actuators without electrical separation�
6.2 General wiring information
The supply cables and the CAN2 interface are connected via the X1 connector
on the bottom of the device� The inputs/outputs, the CAN1 interface and the CAN
supply are connected via the M12 connectors on the front side of the housing�
Wiring (→ 9 Technical data)
Bekijk gratis de handleiding van IFM CR2042, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | CR2042 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13158 MB |
